Removing and Replacing Hopper, Front and Back Covers
Back Cover | |
To access the motor and all other components, it is | Replacing Cover |
necessary to remove the hopper, front and back covers. |
|
| 1 To reposition cover |
Removing Cover | on sprayer frame, |
| tip the cover back, |
1 Completely | toward you and |
remove 6 | slide it down, into |
screws (2 on top | place in the base of |
and each side) | the frame. Then |
from cover. | push the top back |
| into place. Align |
| screw holes in side |
ti4430a | and top of cover |
| with holes in frame. |
ti4432a
2Lift cover up and then tilt it back and off sprayer frame.
2Replace and tighten screws.
ti4433a
ti4431a
10 | 310645H |