Removing and Replacing Belt
Removing and Replacing Belt
Use Belt Replacement Kits 118845.
First read and follow instructions in the Before performing any service on sprayer section, page 9.
Then remove hopper, front and back covers, page 9.
Remove hose extension and RotoFlex HD Pump assembly from frame, page 11.
Removing Belt
Replacing Belt
1Using new belt from Kit, position new belt around pulleys making sure the teeth in the belt are properly engaged with teeth on pulleys.
ti4392a
1Loosen 4 bolts (2 each side) to loosen tension on belt.
2Loosen 2 bolts (1 each side) holding down sup- port rod.
3Using a screw driver for leverage, lift up on motor support rod on one side of motor and ease it out of the holding bracket far enough to remove old belt. Discard old belt.
At the same time, slide in the new belt.
ti4459a
2Replace support rod. Tighten 2 bolts (1 each side) to secure support- ing rod.
ti4388b
3Insert crow bar under assembly as shown and raise motor assembly until desired belt ten- sion is achieved.
ti4388a
4While holding motor assembly in place with crow bar. Spin pulley to assure proper belt engagement. Adjust motor assembly position as necessary.
ti4391a
ti4393a
ti4469a
ti4472a
310645H | 19 |