I.C.T.C. Holdings Corporation 1150GSD Important Safety Precautions, Table of Contents

Page 3

TABLE OF CONTENTS

 

For greatest user satisfaction, please familiarize

 

yourself with all maintenance and operational instructions

 

Important Safety Precautions

3-4

Introduction

5

Operating Instructions

5

Setting Up To Spray

6-7

Flushing The Unit

8

Special Notes

9

Airless Spray Painting Suggestions

10-12

Trouble Shooting

13-21

Hydrapulse Membrane Replacement

22

Intake Seat Replacement

23

Piston Repairs

24-25

Outgo Valve

26

Prime Valve Repairs

27

Pressure Control Valve Repairs

28

Accessories

29

Parts List And Descriptions

30-34

Exploded Unit Diagram

35-36

Depot List

37-40

IMPORTANT

 

NOTE: AS WITH ALL MECHANICAL EQUIPMENT, PROPER OPERATING AND MAINTENANCE PROCEDURES ARE REQUIRED TO KEEP YOUR H.E.R.O. AIRLESS PUMP PERFORMING TO YOUR SATISFACTION. THE FOLLOWING SAFETY, OPERATING AND MAINTENANCE INSTRUCTIONS ARE IMPORTANT.

Read and understand this manual completely, especially with regard to all safety precautions. Read and follow instructions on all warning labels on your equipment. Keep the warning labels clean and readable at all times. Order new labels from your local distributor or from H.E.R.O. Industries Ltd. if needed.

The manufacturer shall not be responsible for any loss, damages, or injury of any kind or nature whatsoever resulting from the use the equipment other than in strict compliance with the instructions, cautions and warnings contained in this operating and instruction manual and as displayed on the face of the equipment.

This system is capable of producing 2400 psi. ( spray pressure ). To avoid rupture and injury DO NOT operate this pump with components rated less than 3000 psi. working pressure (including but not limited to spray guns, hose and connections).

Before servicing, cleaning or removing of any part, shut off power and relieve pressure.

IMPORTANT SAFETY PRECAUTIONS

H.E.R.O. INDUSTRIES

2

1150GSD MANUAL - “B” VERSION

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Version Beginning AT Serial Number Airless Spray EquipmentR.O. Warranty Table of Contents Important Safety PrecautionsAlways Always R.O. Airless Spray PaintingE R a T I N G Setting UP to SprayInstructions Hydrapulse B Version Beginning AT Serial NumberAlways Paint Straining Special Notes and Instructions Flushing the Unit AT Shutdown Or Color ChangeAirless Spray Painting GAS EngineAirless Spray Painting Suggestions and Technique Suggestions and TechniqueSpray TIP Selection Orifice Size TroubleshootingSpray TIP Replacement TIP Size For ApplicationR.O. Industries 1150GSD Manual B Version Paint Intake Valve Assembly REF# Hydraulic Intake Valve REF# 66Hydraulic Outgo Valve REF# 74, PART# 4-27C Prime Valve REF# 36, PART# Paint Outgo Valve REF# 26, PART# 4-611CSituation Gasoline Engine Wont START/RUN No PRESSURE, Blue Hydraulic Fluid in Paint Troubleshooting Sprayer does not Prime with Paint Spray Pattern is Spotty or Uneven Hydrapulse Membrane ReplacementRemoval Replacement of Intake SeatTools Required Piston RepairsSpecial Notes Outgo Valve REF# Prime Valve Repairs O L S Required Pressure Control ValveO L S Accessories Parts ListZIP TIP INSERT, Available in the Following Sizes Parts ListDescription QTY AssyKIT Outgo Parts Industries 1150GSD Manual B Version Drive Parts Decals 1150GSD Parts Schematic Manual B Version
Top Page Image Contents