Chapter
2
SUPER PRO GUN
Handle Assembly 5105-00-01
See Figs. 9.3 & 9.4 for exploded schematic drawings
1.Carefully install the 5105-9-1 (Trigger Nut Seal) over the 5105-10-1 (Trigger Nut).
2.Coat the 7304-4-1 (Lip Seal) with 6706-3-1 (Pro Gun Oil), and push it into the 5105-10-1 (Trigger Nut).
NOTE
Onceinplacethespringofthe7304-4-1(LipSeal)shouldbefacingout.
3.Screw the 5105-10-1 (Trigger Nut) into the 5105-1-1 (Gun Handle), and tighten. Coat the 5105-14-1 (Trigger Stem) with 6706-3-1 (Pro Gun Oil) and install from the inside cavity of the 5105-1-1 (Gun Handle) through the 5101-10-1 (Trigger Nut).
4.Place the 5105-15-01 (Pivot Plate) into the slot in the
5105-1-1 (Gun Handle Assembly), and push the 7203-4-9 (Slotted Spring Pin) located on the back side of the 5105-16-1 (Trigger) into the hole in the 5105-14-1 (Trigger Stem). Line up the 5105-15-2 (Pivot Plate Bushing) to the lower pivot hole in the Gun Handle, insert the 7102-10-12 (Slotted Flat Head Screw) and tighten.
NOTE
WheninstallingtheTriggerAssemblythe5105-8-1(TriggerLock)mustbein the“down”position.
SUPER PRO GUN & | 3 |
SUPER PRO GUN II | |