Grizzly G9749 owner manual Unpacking Lifting, To unpack and move the drill press

Page 14

The Model G9749 weighs 615 lbs. You will need power lifting equipment and assistance to remove this machine from the pallet and position it. Inspect all lifting equipment and make sure that all is in perfect working order and is rated for the load before attempting to lift and move this drill press. Ignoring this warning may lead to serious personal injury or death.

Unpacking and

Lifting

The Model G9749 was carefully packed when it left our warehouse. If you discover the machine is damaged after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice.

Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.

When you are completely satisfied with the condi- tion of your shipment, you should inventory the contents.

To unpack and move the drill press:

1.Read this entire SETUP section before continuing. Pay special attention to Site Considerations on Page 11 and Mounting to Shop Floor on Page 13.

2.Remove the sides and top of the shipping crate.

3.Position the lifting straps under the headstock as shown in Figure 6. Make sure the straps are not in contact with any controls, wires, or handles.

Figure 6. Location of lifting straps.

4.Position lifting straps, your lifting device, and your assistant to support the drill press in a vertical and stable position.

5.Unbolt the drill press from the pallet.

6.Slowly raise the drill press from the pallet, then carefully move the drill press to your prepared location.

7.With the drill press securely resting on the floor, shim between the floor and drill press base as required to level the drill press table.

8.Secure the drill press to the floor, but DO NOT overtighten the fasteners.

9.Recheck the table to make sure that it is still level, and re-shim as required.

-12-

G9749 Variable Speed Drill Press

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model G9749 Variable Speed Drill Press Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Other Related Information Identification G9749 Variable Speed Drill Press Safety Instructions for Machinery Additional Safety for Drill Presses Amperage Draw Circuit Requirements110/220V Operation Circuit Requirements220V Operation GroundingExtension Cords 110V OperationItems Needed for Setup SetupSetup Safety Site ConsiderationsUnpacking Lifting To unpack and move the drill pressTo mount the drill press to the floor Mounting to Shop FloorBolting to Concrete Floors Inventory Clean Up Contents Figure QtyTo install the table crank handle AssemblyTo install the rapid downfeed handles Components and Hardware Needed QtyTest Run Spindle Break-In To test run the machineOperations Installing Drill ChuckTo install the drill chuck onto the arbor Changing Speeds Installing/Removing Drill BitsTo install a drill bit into the chuck To remove a drill bit from the chuckLubrication Suggestions Using the Drill Bit Speed ChartChoosing Speeds To use the quill lock DrillingQuill Travel To use the depth gauge and depth stop To use the rapid downfeed controlTo use the fine downfeed control Headstock Rotation Table AdjustmentsTo adjust table height and rotation To rotate the headstockRemoving/Installing Arbor and Chuck To remove the arbor and chuck from the spindleTo install the arbor into the spindle with the drawbar To remove the chuck from the arborG1076-52-PC. Clamping Kit AccessoriesH5685-4Rotary Table Unpainted Cast Iron MaintenanceSchedule LubricationTroubleshooting ServiceAbout Service Symptom Possible Cause Possible SolutionDrill Operations G9749 switch wiring Electrical ComponentsWiring Diagram Headstock Parts Breakdown Headstock Components Parts Breakdown Variable Speed Parts Breakdown Base Parts Breakdown Parts List DescriptionFlat Washer 1/4 Label Placement 403 401 405 404 400 402 406Warranty and Returns Page Page
Top Page Image Contents