Assembly |
|
Components and Hardware Needed: | Qty |
Hex Wrench 5mm (provided) | 1 |
Rapid Downfeed Handle Shafts | 3 |
Rapid Downfeed Handle Knobs | 3 |
Table Crank Knob | 1 |
Open End Wrench 9⁄16" | 1 |
To install the rapid downfeed handles: |
|
1.Screw each knob onto the shaft end with the longest thread pattern.
2.Screw the resulting handle assembly into the threaded holes on the rapid downfeed control base (see Figure 10).
Control
Base
Shaft
Knob
Figure 10. Rapid downfeed handles installed in
control base.
3.Use a 9⁄16" wrench to tighten the shaft to the control base.
G9749 Variable Speed Drill Press
To install the table crank handle:
1.Screw the table crank handle into the thread- ed hole on the table crank (see Figure 11).
Handle
Table Crank | Set Screw |
|