Grizzly G9749 owner manual Label Placement, 403 401 405 404 400 402 406

Page 39

Label Placement

403

401
405	404

405

400

402

406

REF	PART #	DESCRIPTION

400	P9749400	MACHINE ID LABEL

401	P9749401	READ MANUAL-HORIZONTAL

402	P9749402	SPEED NOTICE LABEL

403	P9749403	ENTANGLEMENT LABEL

REF	PART #	DESCRIPTION

404	PLABEL-11	SAFETY GLASSES 2" X 3 5/16"

405	PLABEL-14	ELECTRICITY LABEL

406	PLABEL-10	GRIZZLY NAME PLATE

407	PPAINT-1	GRIZZLY GREEN PAINT

Safety labels warn about machine hazards and ways to prevent injury. The owner of this machine MUST maintain the original location and readability of the labels on the machine. If any label is removed or becomes unreadable, REPLACE that label before using the machine again. Contact Grizzly at (800) 523-4777 or www.grizzly.com to order new labels.

G9749 Variable Speed Drill Press

-37-

Image 39

Contents Model G9749 Variable Speed Drill Press Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Other Related Information Identification G9749 Variable Speed Drill Press Safety Instructions for Machinery Additional Safety for Drill Presses Circuit Requirements Circuit Requirements110/220V Operation Amperage Draw110V Operation GroundingExtension Cords 220V OperationSite Considerations SetupSetup Safety Items Needed for SetupTo unpack and move the drill press Unpacking LiftingMounting to Shop Floor Bolting to Concrete FloorsTo mount the drill press to the floor Contents Figure Qty Inventory Clean UpComponents and Hardware Needed Qty AssemblyTo install the rapid downfeed handles To install the table crank handleTo test run the machine Test Run Spindle Break-InInstalling Drill Chuck To install the drill chuck onto the arborOperations To remove a drill bit from the chuck Installing/Removing Drill BitsTo install a drill bit into the chuck Changing SpeedsUsing the Drill Bit Speed Chart Choosing SpeedsLubrication Suggestions Drilling Quill TravelTo use the quill lock To use the rapid downfeed control To use the fine downfeed controlTo use the depth gauge and depth stop To rotate the headstock Table AdjustmentsTo adjust table height and rotation Headstock RotationTo remove the arbor and chuck from the spindle Removing/Installing Arbor and ChuckTo remove the chuck from the arbor To install the arbor into the spindle with the drawbarAccessories H5685-4Rotary TableG1076-52-PC. Clamping Kit Lubrication MaintenanceSchedule Unpainted Cast IronSymptom Possible Cause Possible Solution ServiceAbout Service TroubleshootingDrill Operations Electrical Components G9749 switch wiringWiring Diagram Headstock Parts Breakdown Headstock Components Parts Breakdown Variable Speed Parts Breakdown Base Parts Breakdown Description Parts ListFlat Washer 1/4 403 401 405 404 400 402 406 Label PlacementWarranty and Returns Page Page