Grizzly G9749 owner manual Other Related Information

Page 6

Other Related Information
Base Length	26 in.
Base Width	18-1/2 in.
Quill Hold Type	Lock Lever with Gib
Quill Diameter	3 in.
Depth Stop Type	Threaded Rod with Positive Stop
Column Diameter	4-1/2 in.
Spindle Information
Spindle Taper	MT#3
Spindle Travel	6-1/2 in.
Dist From Spindle To Column	9-3/4 in.
Dist From Spindle To Table	28-3/4 in.
Dist From Spindle To Base	50 in.
Table Information
Table Length	21-3/4 in.
Table Width	19-1/2 in.
Table Thickness	2 in.
Floor To Table Height	18 - 43 in.
Vertical Table Movement	Crank Handle Operate
Table Swivel Around Column	360 deg.
Maximum Movement Of Work Table	25 in.
No. Of T Slots	2
T Slot Width	1/2 in.
T Slot Length	15-1/2 in.
Operation Information
Swing	19-1/2 in.
Drilling Capacity	1-1/4 in.
No Of Spindle Speeds	Variable
Range Of Spindle Speeds	300 - 2000 RPM
Drill Chuck Type	JT6 Key Chuck
Drill Chuck Size	1/2 in.
End Milling Cap	3/4 in.
Face Milling Cap	3 in.
Other Specifications:
ISO Factory	ISO 9001
Country Of Origin	Taiwan
Warranty	1 Year
Serial Number Location	ID Label on Head Casting
Assembly Time	10 minutes

Features:

Graduations in 0.001 Inches Manual Fine Down Feed Quill Lock and Depth Stop MT #3 Spindle Taper Variable Speed

1-1/2HP Motor

Table and Base are Cast Iron

-4-	G9749 Variable Speed Drill Press

Image 6

Contents Model G9749 Variable Speed Drill Press Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Other Related Information Identification G9749 Variable Speed Drill Press Safety Instructions for Machinery Additional Safety for Drill Presses Amperage Draw Circuit Requirements110/220V Operation Circuit Requirements220V Operation GroundingExtension Cords 110V OperationItems Needed for Setup SetupSetup Safety Site ConsiderationsUnpacking Lifting To unpack and move the drill pressMounting to Shop Floor Bolting to Concrete FloorsTo mount the drill press to the floor Inventory Clean Up Contents Figure QtyTo install the table crank handle AssemblyTo install the rapid downfeed handles Components and Hardware Needed QtyTest Run Spindle Break-In To test run the machineInstalling Drill Chuck To install the drill chuck onto the arborOperations Changing Speeds Installing/Removing Drill BitsTo install a drill bit into the chuck To remove a drill bit from the chuckUsing the Drill Bit Speed Chart Choosing SpeedsLubrication Suggestions Drilling Quill TravelTo use the quill lock To use the rapid downfeed control To use the fine downfeed controlTo use the depth gauge and depth stop Headstock Rotation Table AdjustmentsTo adjust table height and rotation To rotate the headstockRemoving/Installing Arbor and Chuck To remove the arbor and chuck from the spindleTo install the arbor into the spindle with the drawbar To remove the chuck from the arborAccessories H5685-4Rotary TableG1076-52-PC. Clamping Kit Unpainted Cast Iron MaintenanceSchedule LubricationTroubleshooting ServiceAbout Service Symptom Possible Cause Possible SolutionDrill Operations G9749 switch wiring Electrical ComponentsWiring Diagram Headstock Parts Breakdown Headstock Components Parts Breakdown Variable Speed Parts Breakdown Base Parts Breakdown Parts List DescriptionFlat Washer 1/4 Label Placement 403 401 405 404 400 402 406Warranty and Returns Page Page