Grizzly G4009, G4008 instruction manual Beginning Assembly Base/Column

SECTION 2: ASSEMBLY

Beginning Assembly Base/Column

Most of the Drill Press has been pre-assembled at the factory. The few remaining pieces should go together quickly and easily. This manual is written for both the G4008 and G4009. The only difference between the two regarding assembly is the length of the column.

CAUTION: All die-cut metal parts have a sharp edge (called “flashing”) on them after they are formed. This is removed at the factory. Sometimes though, a bit of flashing might escape inspection. Please examine the edges of all die- cut metal parts before handling them.

Tools Required: Only a few common tools are needed to assemble this machine. Specifically, a 14mm open end wrench, Phillips screwdriver and 3mm and 4mm Allen wrench.

1.Place the base on the floor (if G4009) or on a suitable bench (if G4008). In either case, be sure the surface is flat and stable.

2.Place the column onto the base, line up the four holes and secure with the four M10-1.5 x 40mm Hex Head Bolts and lock washers pro- vided. Figure 3.

Figure 3.

-8- G4008/G4009 Drill Press