Grizzly G4009, G4008 instruction manual Working Table

Working Table

1.Place the crank handle onto the raise/lower shaft and tighten down. Figure 6.

Figure 6.

2.Insert the M16-2.0 x 40 cap screw through the hole located on the bottom/rear of the table bracket.

3.Thread the cap screw into the column bracket and tighten down. Figure 7.

Figure 7.

4.Place the table into the hole in the table brack- et and secure with the table lock handle.

Figure 8.

Figure 8.

5.Thread the column lock handle into the col- umn bracket. Leave the lock handle loose for now. Figure 9.

Figure 9.

-10- G4008/G4009 Drill Press