SECTION 5: ADJUSTMENTS
Speed Change | Depth Stop | |
|
|
|
|
|
|
Remember to disconnect the drill press from the power source before attempting any adjustments.
1.Loosen the two lock knobs, one on either side of the head. Figure 13.
2.Turn the cam lever so the motor pulley moves toward the center pulley. Figure 13.
3.Select the desired speed. Open the top cover and move the belts into the corresponding position for the selected speed.
4.Rotate the cam lever so the motor pulley moves away from the center pulley and tight- en locking screws on both sides of the head.
CAUTION: Never run the drill press with the cover open.
Figure 13.
To stop the vertical travel of the drill bit at a desired depth, loosen the scale set knob located on the feed shaft assembly, rotate the collar to the desired depth and tighten the scale set knob.
Figure 14.
To hold a stationary depth, loosen the scale set knob and rotate the feed shaft to the desired depth. Then, rotate the collar clockwise until it stops and tighten the scale set knob. This will lock the spindle at the desired depth.
Scale Set Knob
Figure 14.
|
|
|
|
|
|
|
|
|
|
|
|
G4008/G4009 Drill Press | |||