Motor |
| Motor Wiring |
|
|
|
|
|
|
1.Remove the motor mount bolts from the motor mount.
2.You will need help for this step: Attach the motor to the motor mount using the hardware removed in Step 1. Lightly tighten down the bolts.
3.Slide the motor pulley onto the motor shaft lining up the setscrew with the flat spot on the motor shaft. Tighten the setscrew.
4.Install the
Figure 10.
Figure 10.
1.Remove the wire box cover located at the end of the motor.
2.Wire the motor per the diagram in Figure 11.
NOTE: The wires from the switch, besides the ground wire, are interchangeable; therefore their colors are not specified.
3.Attach the ground wire securely to the green screw located on the back of the motor.
4.Attach motor wire cover.
5.If the motor runs backwards, reverse the positions of motor wires #5 and #8.
Figure 11.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
G4008/G4009 Drill Press | ||||||