Grizzly G0463 owner manual Electrical Components, Circuit board

Page 29

Electrical Components

Figure 30. Circuit board.

Figure 31. Equipment grounds.

System Light

 

 

E-Stop

Power Light

 

 

 

 

 

 

 

Figure 32. E-Stop and indicator lights.

G0463 Small Mill/Drill

Figure 33. RPM control.

Figure 34. Forward/Reverse switch.

Figure 35. Main power switch.

-27-

Image 29
Contents Model G0463 Small MILL/DRILL Page Table of Contents Accessories Maintenance Contact Info IntroductionForeword Shipping Dimensions Product DimensionsElectrical MotorFeatures Main SpecificationsTable Info ConstructionIdentification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Mill/Drills 110V Operation Circuit RequirementsSet Up Safety SET UPItems Needed for Set Up UnpackingItems not shown InventoryBox 1 Figures 3 Qty Site Considerations Clean UpFeet To install the feet on the mill/drillMounting to Workbench Components and Hardware Needed QtyTest Run Spindle Break-in To begin the start up and break-in procedureTo remove the chuck and arbor from the spindle Drill Chuck RemovalTools Needed Qty To remove the collet To install the R-8 colletCollets Operations Operation SafetyPower Controls To completely shut the system power OFF Power ShutdownSpindle & Headstock Controls To use the rapid downfeedCross Feed Table TravelLongitudinal Feed To determine the needed RPM Setting RPMCutting Speed x 4 /Tool Diameter = RPM Cutting Speeds for High Speed Steel HSS Cutting ToolsAccessories G2861-21⁄2 Face Mill G9324-Boring Head Combo SetH2689-R-8 Quick Change Collet Set H5685-4Rotary TableSchedule MaintenanceUnpainted Cast Iron LubricationTroubleshooting ServiceAbout Service To adjust the gibs see Figure Adjusting GibsReplacing Motor Brushes & Fuse To replace the motor brushesCircuit board Electrical ComponentsWiring Diagram Parts Breakdown 237 238 240 241 236 242 235 234 Description Parts ListPK30M Emergency Stop Switch Warranty and Returns Page Page