Grizzly G0463 owner manual Operations, Operation Safety, Power Controls

Page 20

SECTION 4: OPERATIONS

Operation Safety

Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety

Power Controls

It is vital that you become familiar with the power controls before operating the Model G0463. Three separate switches control the power on the mill/drill (see Figure 10).

glasses, a respirator, and hearing protection when operating this machine.

1

2

3

4 5

6

Loose hair and cloth-

ing could get caught in

machinery and cause seri-

ous personal injury. Keep

loose clothing and long

hair away from moving machinery.

NOTICE

If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.

7

Figure 10. Control panel components.

1.EMERGENCY STOP Button: Immediately disconnects power to the system. Once pressed, this button must be twisted until it pops out to return power to the switches. The FAULT INDICATOR Light will turn on and the MAIN POWER Switch needs to be turned OFF.

2.FAULT INDICATOR Light: Indicates a cir- cuit interruption due to a switch being out of proper position. Turn all switches OFF when lit.

3.POWER INDICATOR Light: Shines when the system power is ON.

4.Fuse Socket: Houses a 10 Amp system fuse.

-18-

G0463 Small Mill/Drill

Image 20
Contents Model G0463 Small MILL/DRILL Page Table of Contents Accessories Maintenance Contact Info IntroductionForeword Product Dimensions Shipping DimensionsElectrical MotorMain Specifications FeaturesTable Info ConstructionIdentification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Mill/Drills Circuit Requirements 110V OperationSET UP Set Up SafetyItems Needed for Set Up UnpackingItems not shown InventoryBox 1 Figures 3 Qty Clean Up Site ConsiderationsTo install the feet on the mill/drill FeetMounting to Workbench Components and Hardware Needed QtyTo begin the start up and break-in procedure Test Run Spindle Break-inTo remove the chuck and arbor from the spindle Drill Chuck RemovalTools Needed Qty To remove the collet To install the R-8 colletCollets Operations Operation SafetyPower Controls Power Shutdown To completely shut the system power OFFSpindle & Headstock Controls To use the rapid downfeedCross Feed Table TravelLongitudinal Feed Setting RPM To determine the needed RPMCutting Speed x 4 /Tool Diameter = RPM Cutting Speeds for High Speed Steel HSS Cutting ToolsAccessories G9324-Boring Head Combo Set G2861-21⁄2 Face MillH2689-R-8 Quick Change Collet Set H5685-4Rotary TableMaintenance ScheduleUnpainted Cast Iron LubricationTroubleshooting ServiceAbout Service Adjusting Gibs To adjust the gibs see FigureReplacing Motor Brushes & Fuse To replace the motor brushesElectrical Components Circuit boardWiring Diagram Parts Breakdown 237 238 240 241 236 242 235 234 Parts List DescriptionPK30M Emergency Stop Switch Warranty and Returns Page Page