Grizzly G0758 owner manual Table Travel, Graduated Dials, Axis Handwheel, Tool Needed Qty

Table Travel

The table travels in two directions and is con- trolled by handwheels, as illustrated in Figure 23:

•X-axis (longitudinal)

•Y-axis (cross)

X-Axis or Longitudinal Travel

(Left & Right)

Y-Axis or

Cross Travel (In & Out)

Figure 23. Possible directions of table travel.

Graduated Dials

The handwheels have graduated dials that are used to determine table movement in 0.002" increments, with one full revolution equalling 0.100".

Rotate graduated dial to a relative starting point (see Figure 24).

Graduated Dial

Figure 24. Graduated dial location.

-24-

X-Axis Handwheel
Tool Needed	Qty
Hex Wrench 5mm	1

To use X-axis handwheel:

1.Loosen both X-axis table locks shown in

Figure 25.

Note: To readjust positioning of table locks, pull out and rotate.

Table Stops
X-Axis
Table Locks	Y-Axis
	Table Locks

Figure 25. X- and Y-axis table travel locks.

2.Position table stops along front of table to restrict table travel.

3.Adjust X-axis graduated dial to zero, then use handwheel to move table.

Y-Axis Handwheel

The saddle does not have limit stops. To move the table along the Y-axis, loosen the Y-axis table locks shown in Figure 25, then use the handwheel in front of the table in the same man- ner as the X-axis handwheel.

Model G0758 (Mfd. Since 2/14)