Grizzly G0758 owner manual Bench Mounting, Assembly, Diameter of Mounting Hardware, Workbench

Page 19

Bench Mounting

Number of Mounting Holes

4

Diameter of Mounting Hardware

1⁄2"

The base of this machine has mounting holes that allow it to be fastened to a workbench or other mounting surface to prevent it from moving during operation and causing accidental injury or damage.

The strongest mounting option is a "Through Mount" (see example below) where holes are drilled all the way through the workbench—and hex bolts, washers, and hex nuts are used to secure the machine in place.

Hex

Bolt

Flat Washer

Machine Base

Workbench

Flat Washer

Lock Washer

Hex Nut

Figure 11. Example of a "Through Mount" setup.

Another option is a "Direct Mount" (see example below) where the machine is secured directly to the workbench with lag screws and washers.

Lag Screw

Flat Washer

Machine Base

Workbench

Figure 12. Example of a "Direct Mount" setup.

Model G0758 (Mfd. Since 2/14)

Assembly

Except for the handwheel handles, the mill/drill was fully assembled at the factory.

Use a standard screwdriver to attach handwheel handles (see Figures 13–14).

Table Handwheel

Handles

Figure 13. X- and Y-axis handwheel handles

attached.

Vertical Handwheel Handle

Figure 14. Z-axis handwheel handle attached.

-17-

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model G0758 MILL/DRILL Page Table of Contents Machine Description Manual Accuracy IntroductionContact Info Right side identification Model G0758 Mfd. Since 2/14 IdentificationControls Components Machine Data Sheet Table Info Safety Instructions for Machinery SafetyPage Additional Safety for Mills/Drills 110V Circuit Requirements Power SupplyAvailability Full-Load Current Rating50 ft Grounding & Plug RequirementsExtension Cords Minimum Gauge Size 16 AWGDescription Qty SetupNeeded for Setup UnpackingInventory Figure Qty InventoryBefore cleaning, gather the following CleanupBasic steps for removing rust preventative Site Considerations To lift machine and place it in position Lifting & PlacingWorkbench AssemblyBench Mounting Diameter of Mounting HardwareLubricating Mill/Drill Joining Drill Chuck ArborTo join drill chuck and arbor Test Run Spindle Break-In Inspections AdjustmentsOperation Overview OperationsDownfeed Controls Using Coarse DownfeedUsing DRO Using Fine DownfeedTools Needed Qty Headstock MovementRaising/Lowering Headstock Tilting HeadstockTool Needed Qty Table TravelGraduated Dials Axis HandwheelInstalling Tooling Installing/Removing ToolingTo install tooling To remove tooling Spindle SpeedRemoving Tooling Determining Spindle SpeedT26612-Optional Stand for Model G0758 AccessoriesLubrication MaintenanceCleaning Protecting ScheduleAxis Leadscrews Table and Column WaysTo lubricate Z-axis leadscrew To lubricate headstock gears Table LeadscrewsHeadstock Gears To lubricate table leadscrewsQuill Outside Surface Replacing DRO BatteryQuill Rack Troubleshooting ServiceSymptom Possible Cause Possible Solution Symptom Possible Cause Possible Solution Adjusting Leadscrew Backlash Adjusting GibsTo inspect and replace motor brushes Brush ReplacementWiring Safety Instructions WiringWiring overview Model G0758 Mfd. Since 2/14 G0758 Wiring OverviewGND G0758 WiringRear panel Column PartsDescription Electrical Box Headstock Description Chip Guard Labels & Cosmetics Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCWarranty & Returns
Top Page Image Contents