Safety Precautions
3"
1X
3X
3"
3" 3"
6.Do not drive power fasteners into concrete less than three times as thick as the intended fastener penetration, within 3" of the edge, within 3" of another power fastener or within 3" of a failed power fastener.
WELD
1"
1/2"
TOO THIN | 3/16" MIN |
|
7.Do not drive power fasteners into steel base material less then 3/16" thick, within 2" of a weld, within 1/2" of the edge or within 1" of another power fastener.
NO | YES |
|
8.When fastening into masonry walls, always drive into horizontal mortar joints, never into vertical mortar joints. Be careful. A poorly laid joint may permit too much penetration, and/or unsatisfactory holding power.
OPERATING THE TOOL
90˚
1.Always hold tool perpendicular to work surface.
8 | 099494 |