Ryobi HD1830 manual Turning ON/OFF the Hammer Drill, Reversible

Page 14

OPERATION

TURNING ON/OFF THE HAMMER DRILL

See Figure 10.

Follow these steps to turn on/off the hammer drill.

Turn on the hammer drill: Depress the trigger switch.

Turn off the hammer drill: Release the trigger switch.

VARIABLE SPEED

See Figure 10.

Your drill has a variable speed feature in the switch. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

SWITCH LOCK

See Figure 10.

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.

REVERSIBLE

See Figure 10.

This tool is reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.

CAUTION:

To prevent gear damage, always allow chuck to come to a complete stop before changing the speed or the direction of rotation.

To stop, release switch trigger and allow the chuck to come to a complete stop.

WARNING:

Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or when carrying at your side.

DIRECTION OF

ROTATION SELECTOR

SWITCH TRIGGER

Fig. 10

Page 14

Image 14
Contents Operators Manual Save this Manual for Future ReferenceTable of Contents IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaImportant Rules for Battery Tools Specific Safety RulesService Additional Rules for Safe OperationImportant Safety Instructions for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONApplications SpecificationsUnpacking InstructionsDepth Gauge ROD FeaturesAuxiliary Handle Assembly Switch Trigger BIT Storage Area Battery Pack Adjusting the Depth Gauge ROD AdjustmentsAdjusting the Auxiliary Handle Assembly Adjusting the Torque Removing Bits Changing the BIT RotationInserting Bits WrongTo Charge OperationCharging Your DRILL-DRIVER LED Function of ChargerTurning ON/OFF the Hammer Drill ReversibleThree Speed Gear Train BIT Storage To Install Battery PackTo Remove Battery Pack Electric BrakeDrilling Tightening the Chuck MaintenanceRemoving the Chuck Batteries Disposal of the Exhausted BatteryBattery Pack Preparation for Recycling Service Model NO. and Serial no