ASSEMBLY
WARNING:
To prevent accidental starting that could cause possible serious personal injury, assemble all parts, make sure all adjustments are complete, and make sure all fasteners are secure before connecting saw to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, installing or re- moving blades, or when not in use.
As mentioned previously your saw has been factory as- sembled and adjusted. The miter lock handle, dust guide or dust bag, table extensions, stop block, and blade are the only parts that have to be installed.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on the end of the miter lock handle into the threaded hole in the control arm under miter table. Turn clockwise to tighten.
DUST GUIDE
See Figure 8.
To install the dust guide, place the end marked INSERT over the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down.
TO INSTALL BLADE
See Figures 9, 10, and 11.
WARNING:
A 10 in. (254 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from securing the blade on the spindle. Either of these situa- tions could result in a serious accident and can cause serious personal injury.
■Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental starting causing possible serious personal injury.
■Insert the wrench provided through slot in lower blade guard bracket and loosen screw A, securing the blade bolt cover, approximately
■Rotate lower blade guard up and remove screw B. Ro- tate blade bolt cover up and back to expose the blade bolt.
■Push down on the saw arm and pull out the lock pin to release saw arm. Raise saw arm to its full raised posi- tion. Be cautious, saw arm is spring loaded to raise.
MITER
TABLE
8 7 
6 
5 
4 
3 
2 1
TO
TIGHTEN
CONTROL ARM | TO | |
MITER | ||
LOOSEN | ||
LOCK HANDLE | Fig. 7 | |
UPPER |
| |
BLADE GUARD |
| |
EXHAUST |
| |
PORT |
|
DUST GUIDE
|
|
|
|
|
|
|
| Fig. 8 |
ROTATE SAW ARM DOWN | ROTATE SAW ARM UP | |||||||
TO EXPOSE SCREW A | TO EXPOSE SCREW B | |||||||
SLOT | SCREW A | SCREW B | ||||||
|
|
|
|
| de | ly | ||
|
|
|
| bla |
| |||
|
|
|
|
| ure |
|
| |
|
|
| w | er c |
| w |
| |
|
|
| se |
|
| . | ||
|
|
| lo d screse | |||||
|
|
| re an | n | re | u |
|
|
|
|
| sto | te |
|
|
| |
|
|
| e ard h |
|
|
|
|
|
|
| R | gu tig befo |
|
|
|
| |
Restore lower blade guard and securely tighten screw before use.
R |
|
gestore low | |
uard and ser blade | |
tighten | ecurely |
| screw |
before use. | |
Fig. 9
Page 12