Ryobi TS1301 warranty Support Long Workpieces, Long Workpiece Workpiece Supports

Page 19

OPERATION

■Before turning on the saw, perform a dry run of the cutting operation just to make sure that no problems will occur when the cut is made.

■Grasp the saw handle firmly then squeeze the switch trigger. Allow several seconds for the blade to reach maximum speed.

■Slowly lower the blade into and through the workpiece.

■Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of workpiece. Wait until the electric brake stops blade from turning before removing the workpiece from the miter table.

SUPPORT LONG WORKPIECES

See Figure 26.

Long workpieces need extra supports. Supports should be placed along the workpiece so it does not sag. The support should let the workpiece lay flat on the base of the saw and work table during the cutting operation. Use the work clamp or a C-clamp to secure the workpiece.

WARNING:

To avoid serious personal injury, always keep your hands outside the no hands zone and at least 3 in. (76.2 mm) from blade. Never perform any cutting operation freehand (without securing workpiece against the fence). The blade could grab the workpiece if it slips or twists.

8 7 6 5 4 3

LONG WORKPIECE

WORKPIECE SUPPORTS

Fig. 26

Page 19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Thank YOU for Buying a Ryobi Miter SAW Save this Manual for Future ReferenceTable of Contents Rules for Safe Operation Symbol Meaning Safety Alert SymbolDouble Insulation Read ALL Instructions Before Making a CUT, be Sure ALL Adjustments are Secure Additional Rules For Safe Operation For Miter Saws Glossary of Terms for Woodworking Unpacking and Checking Contents Features Positive Stops on Miter Table Miter Lock HandleSpindle Lock Button Trigger LockTrace Holes Optional AccessoriesMounting Hole Electrical ConnectionTo Install Blade AssemblyDust Guide Dust BAG Stop Block Table ExtensionsPivot Adjustments Travel Pivot Adjustment AdjustmentsAuthorized Service Center FEN CE Squaring the Miter Table to the FenceSee Figures 17 Fence Miter TableFence Miter Blade Framinglock Plate Square FENCE, Adjustments are Required FigSquaring the SAW Blade to the Fence See Figures 21Crosscutting OperationApplications Cutting with Your Miter SAWLong Workpiece Workpiece Supports Support Long WorkpiecesRight Cutting Warped MaterialClamping Wide Workpieces See Figures 27Extension Cords MaintenanceGeneral LubricationProceed as follows when replacement is required Brush ReplacementBrush CAP Assembly Problem Cause Solution TroubleshootingRyobi TECHNOLOGIES, INC Operators Manual 10 in mm Miter Saw Model TS1301
Top Page Image Contents