Ryobi TS1301 warranty Table Extensions, Stop Block

Page 14

ASSEMBLY

TABLE EXTENSIONS

See Figures 13, 14, and 15.

If you plan to use the stop block, slide the stop block on the back arm of the desired table extension first. See Figure 13.

To install table extensions, insert the ends of extensions into the holes in the sides of the base. See Figures 13 and 14. Adjust the extensions to the desired length.

Secure them in place by positioning a clamp bracket under each table extension beneath the miter table. Orient each clamp bracket as shown in figure 15.

Secure each clamp bracket in place with a clamp bracket screw. The clamp bracket screw threads through the clamp bracket and tightens against bracket support on bottom of miter table, securing clamp bracket against table extension.

STOP BLOCK

See Figures 13 and 16.

The stop block is included with the Table extensions and is useful as a stop for making repetitive cuts to the same length. It can be installed on either side of the saw base:

■Slide the stop block on the back arm of either table extension, then insert the table extensions into the saw base. See Figure 13.

■Use the small wing screw to secure the stop block to the table extensions. See Figure 13.

■Loosen the small wing screw and adjust the stop block the desired distance from the blade for the cut to be made. For accurate placement of the stop block, mea- sure the distance from the teeth set on the blade to the stop block.

■Tighten wing screw securely.

■Make a test cut in scrap material and measure the length of the workpiece.

■Make any necessary adjustments.

TABLE

 

 

 

 

8

2

3

4

5

MITER

 

1

 

 

 

SAW BASE

 

Fig. 14

MITER

SAW VIEWED FROM BOTTOM

BRACKET

SAW BASE

 

SUPPORT

 

CLAMP

TABLE

BRACKET

ASSEMBLED

EXTENSION

 

CLAMP

BRACKET

CLAMP

BRACKET SCREW

Fig. 15

WARNING:

Always make sure your miter saw is securely mounted to a workbench or an appropriate workstand. Failure to do so could result in an accident resulting in possible serious personal injury.

STOP BLOCK

8

SMALL

WING SCREW

TABLE

EXTENSION

STOP

5 4 3 2 1

MITER

SAW BASE

Fig. 13

Page 14

Fig. 16

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Save this Manual for Future Reference Thank YOU for Buying a Ryobi Miter SAWTable of Contents Double Insulation Symbol Meaning Safety Alert SymbolRules for Safe Operation Read ALL Instructions Before Making a CUT, be Sure ALL Adjustments are Secure Additional Rules For Safe Operation For Miter Saws Glossary of Terms for Woodworking Unpacking and Checking Contents Features Trigger Lock Miter Lock HandleSpindle Lock Button Positive Stops on Miter TableElectrical Connection Optional AccessoriesMounting Hole Trace HolesDust Guide AssemblyTo Install Blade Dust BAG Table Extensions Stop BlockAuthorized Service Center AdjustmentsPivot Adjustments Travel Pivot Adjustment Fence Miter Table Squaring the Miter Table to the FenceSee Figures 17 FEN CESee Figures 21 FENCE, Adjustments are Required FigSquaring the SAW Blade to the Fence Fence Miter Blade Framinglock Plate SquareCutting with Your Miter SAW OperationApplications CrosscuttingSupport Long Workpieces Long Workpiece Workpiece SupportsSee Figures 27 Cutting Warped MaterialClamping Wide Workpieces RightLubrication MaintenanceGeneral Extension CordsBrush CAP Assembly Brush ReplacementProceed as follows when replacement is required Troubleshooting Problem Cause SolutionOperators Manual 10 in mm Miter Saw Model TS1301 Ryobi TECHNOLOGIES, INC
Top Page Image Contents