Ryobi TS1300 Features, Know Your Miter SAW, AMP Motor, Cutting Capacities, Carrying Handle

FEATURES

KNOW YOUR MITER SAW

See Figure 2.

Before attempting to use your saw, familiarize yourself with all operating features and safety requirements.

WARNING:

Do not allow familiarity with your miter saw to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.

14 AMP MOTOR

Your saw has a powerful 14 amp motor with sufficient power to handle tough cutting jobs. It is made with all ball bearings, and has externally accessible brushes for ease of servicing.

10 in. (254 mm) CARBIDE TIPPED BLADE

A 10 in. (254 mm) carbide tipped saw blade is included with your miter saw. It is fine for most wood cutting operations, but for fine joinery cuts or cutting plastic, use one of the accessory blades available from your nearest Ryobi dealer.

CUTTING CAPACITIES

When the miter angle (miter table) is set at 0°:

Your saw will cut dimensional lumber up to a 2 x 6.

It will cut dimensional lumber up to the thickness of a 4 x 4.

When the miter angle (miter table) is set at 45°:

Your saw will cut dimensional lumber up to a 2 x 4.

CARRYING HANDLE

See Figure 3.

For convenience when carrying or transporting your miter saw from one place to another, a carrying handle has been provided on top of the saw arm as shown in figure 3. To transport, turn off and unplug your saw, then lower the saw arm and lock it in the down position. Lock saw arm by depressing the lock pin. Tighten the miter lock handle. Remove the saw from the workbench or workstand. It is now ready to transport.

	SAW ARM	SWITCH
	UPPER	LOCK-OFF LEVER
DUST BAG
	BLADE GUARD
		GER
		DAN
		SWITCH TRIGGER

FENCE

WORK CLAMP

MITER

TABLE BASE

STOP

BLOCK

TABLE

EXTENSION 8 mm WORK CLAMP SCREW

LOWER

BLADE GUARD

MITER TABLE

NO HANDS

ZONE LABEL

	"NO HANDS ZONE"
	BOUNDARY LINE
	45
30	MITER SCALE
15
0
15
0

	MITER
	LOCK PLATE
	MITER
CONTROL ARM	LOCK HANDLE
POSITIVE STOP (S)

Fig. 2

Page 9