Hobart Welding Products M-25 GUN, 2510 specifications Threading Welding Wire

2-14. Threading Welding Wire

Tools Needed:	1	Wire Spool
	2	Welding Wire
	3	Inlet Wire Guide
	4	Pressure Adjustment Knob
	5	Drive Roll
4	6	Outlet Wire Guide
	7	Gun Conduit Cable

7

Lay gun cable out straight.

1	2	3	5	Ref. ST-801 789-A / Ref. ST-802 064 / S-0627-A
				6

.Hold wire tightly to keep it from unraveling.

4 in (102 mm)

6 in (150 mm)

Open pressure assembly.	Pull and hold wire; cut off end.	Push wire thru guides into gun;
		continue to hold wire.
	Tighten

Close and tighten pressure assembly, and let go of wire.

Press gun trigger until wire comes out of gun. Reinstall contact tip and nozzle

Remove gun nozzle and contact tip. Turn On.

WOOD
Feed wire to check drive roll pressure.	Cut off wire.
Tighten knob enough to prevent slipping.	Close door.

OM-194 430 Page 16