.A complete Parts List is available at www.HobartWelders.com
5-9. Threading Welding Wire
4
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Conduit Cable
Lay gun cable out straight.
6
Tools Needed:
1 | 2 | 3 | 5 |
1
Open pressure assembly. Make sure feed roll is set to correct groove to match wire size (see Section
3
2
.Hold wire tightly to keep it from unraveling.
6 in (150 mm)
Pull and hold wire; cut off end.
4 in (102 mm)
Straighten approximately 3 or 4 inches (76 or 102 mm) of wire before inserting
wire into guides. Push wire thru guides into gun; continue to hold wire.