.A complete Parts List is available at www.HobartWelders.com
4 | Tighten |
1
2
3
4
.Use pressure indicator scale to set
a desired drive roll pressure. (Start | 5 |
with a setting of 2 or 3 on the scale.) |
|
Pressure
Indicator
Scale
Be sure that wire is positioned in proper feed roll groove. Close and tighten pressure assembly, and let go of wire.
Remove gun nozzle and contact tip.
6 | 7 |
Turn power on. Be sure that Voltage range switch is set to range 1, 2, 3, or 4 to feed wire. Rotate knob until it “clicks” into detent. Wire will not feed if range switch is set between ranges.
8
Be sure that tip matches wire diameter. Reinstall contact tip and nozzle.
Press gun trigger until wire comes out of gun. (Keep gun cable as straight as possible.)
9
Tighten
1
2
3
4
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Cut off wire. Close door.
Ref. 803