Hobart Welding Products 140 manual Operation, Controls, Source or -2. Do not switch under load

.A complete Parts List is available at www.HobartWelders.com

SECTION 6 − OPERATION

6-1. Controls

1 2

NE PAS CHANGER

DE PROCÉDÉ

1 Wire Speed Control

Use control to select a wire feed speed. As Voltage switch setting increases, wire speed range also increases (see weld setting label in welding power source or Section 6-2).

3

2Power Switch

3Voltage Switch

The higher the selected number, the thicker the material that can be welded (see weld setting label in welding power

Ref. 230 002-A

source or Section 6-2). Do not switch under load.

.Switch must “click” into detent position for weld output.

OM-925 Page 20