Epson 50-764 instruction manual Casters, Legs to MOTOR/BLOWER Assembly

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

A

THIS MACHINE IS HEAVY. USE TWO

OR MORE PEOPLE WHEN LIFTING.

CASTERS
1.	Turn stand (A) upside down, as shown in Fig 1F.	B
2.	Align holes in caster assembly (B) with holes in
	plates on stand. Place small 5/16” flatwasher on a
	5/16”x3/4” hex head screw. Insert screw through
	hole in caster assembly and thread into hole in
	stand. Repeat for all holes in all casters.

3.Tighten hardware by hand, then set with a 12mm

wrench. Fig. 1F

C

LEGS TO MOTOR/BLOWER		A
ASSEMBLY
1.	Place motor/blower assembly with the motor down.
	(Fig. 2)
2.	Place 3/8” (18 mm) flatwasher on knob (A) Fig. 2.
3.	Align holes (B) on legs with holes (C) in the mo-	B
	tor/blower assembly. Legs should extend up. Insert
	knob through hole (B) in the legs and thread into
		Fig. 2
	hole (C) in the motor/blower assembly. Tighten
	knob securely.
4.	Repeat steps for all knobs on both legs.

D

ATTACHING STAND TO LEGS ON		A
MOTOR/BLOWER ASSEMBLY		B
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.	C	C

Place all four stand posts (A) Fig. 3 into four legs (B) on motor/blower assembly.

Fig. 3

9-English