Heath Zenith SH-5412 manual Motion Sensor Light Control, Operation, Features, Requirements

Motion Sensor

Light Control

Model SH-5412

Meets the ENERGY STAR® guidelines when used with 120 W Max bulbs.

Features

•Turns on lighting when motion is detected.

•Automatically turns lighting off.

•Bulb Saver™ - Extends bulb life by up to 4x standard bulbs. Lights bulb to full bright in under 2 seconds.

•Photocell keeps the lighting off during daylight hours.

•LED indicates motion was sensed (day or night).

This package includes:

Requirements

•The light control requires 120-volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

OPERATION

Mode:	On-Time:	Works: Day	Night
Test	5 Sec	x	x
Normal	1, 5, 10 min.		x
Manual	Until Dawn*		x
	* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the	ON-TIME
bottom of the sensor in the TEST
position.
	10 5 1 TEST
AUTO

Lamp Holders

Cover Plate

Rubber Plug

Plastic Hanger

Put the ON-TIME switch in the 1, 5, ON-TIME

or 10 minute position.

10 5 1 TEST

MANUAL MODE

Sensor

Light Control

2 Wire

Connectors

Mounting Bolt Mounting Strap

6 Screws

(3 sizes included)Gasket 2 Shells

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

... back on.

© 2008 HeathCo LLC 598-1158-04