Enerco TSBF10LP Warranty Information, Model Serial No Date Purchased, Keep this warranty

Page 24

WARRANTY INFORMATION

Keep this warranty

Model _______________________

Serial No. ____________________

Date Purchased _______________

Model #

Start Serial #

MH/HS/TSBF10LP MHC-705150003486

MH/HS/TSBF20LP MHC705250007110

MH/HS/TSBF30LP MHC-705350012646

MH/HS/TSIR10LP MHC-705450002399

MH/HS/TSIR20LP MHC-705550007140

MH/HS/TSIR30LP MHC-705650010689

Always specify model and serial numbers when communicating with the factory.

We reserve the right to amend these specifications at any time without notice. The only warranty appli- cable is our standard written warranty. We make no other warranty, expressed or implied.

Enerco Group, Inc. warrants this product to be free from defects in materials and components for one (1) year from the date of first purchase, provided that the product has been properly installed, operated and maintained in accordance with all applicable instructions. To make a claim under this warranty the Bill of Sale or cancelled check must be presented.

The warranty is extended only to the original retail purchaser. This warranty covers the cost of part(s) required to restore the heater to proper operating condition and an allowance for labor when provided by an Enerco Group, Inc. Authorized Service Center. Warranty part(s) MUST be obtained through authorized dealers of this product and/or Enerco Group, Inc. who will provide original factory replacement parts. Failure to use original factory parts voids this warranty. The heater MUST be installed by a qualified in- staller in accordance with all local codes and instructions furnished with the unit.

This warranty does not apply to parts that are not in original condition because of normal wear and tear of parts that fail or become damaged as a result of misuse, accidents, lack of proper maintenance or defects caused by improper installation. Travel, diagnostic cost, labor, transportation and any and all such costs related to repairing a defective heater will be the responsibility of the owner.

TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURISDICTION THAT GOVERNS THE SALE OF THE PRODUCT; THIS EXPRESS WARRANTY EXCLUDES ANY AND ALL OTHER EXPRESSED WARRANTIES AND LIMITS THE DURATION OF ANY AND ALL IMPLIED WARRANTIES OF MER- CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, TO ONE (1) YEAR OF ALL COMPO- NENTS FROM THE FIRST DATE OF PURCHASE; AND ENERCO GROUP, INC.’S LIABILITY IS HEREBY LIMITED TO THE PURCHASE PRICE OF THE PRODUCT AND ENERCO GROUP, INC. SHALL NOT BE LIABLE FOR ANY OTHER DAMAGES WHATSOEVER INCLUDING INDIRECT, INCIDENTAL OR CONSE- QUENTIAL DAMAGES.

Some states do not allow a limitation on how long an implied warranty lasts or an exclusion or limitation on incidental or consequential damages, so the above limitation on implied warranties, or limitation on dam- ages, may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights that vary from state to state. Always specify model and serial number when communicating with the factory.

ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135

 

216-916-3000 Toll Free Number 1-800-251-0001

 

www.mrheater.com

 

Mr. Heater is a registered trademarks of Enerco Group, Inc.

ANSI Z21.11.2b-2004

© 2005, Enerco/Mr. Heater. All rights reserved

 

24 Installation instructions and Owner’s Manual 70575 Rev. E 04/07

Image 24
Contents Blue Flame Heaters Plaque Heaters Model # Burn RateWhat to do if YOU Smell GAS Precautions Carbon Monoxide PoisoningPropane/LP Gas Safety Device Thermostatic Control on Thermostat ModelsLocal Codes Ignition SystemDetermining the Type of Heater Location Space Ventilation AIRVentilation from Inside Building Installation Locating HeaterVentilation from Outdoors Check GAS TypeFastening Heater to Wall Mounting BracketInstalling Bottom Mounting Screws Installing Support Feet see figureConnecting to GAS Supply Placing Heater on Mounting BracketTest pressure in Excess of ½ psig 3.5kPa Test Pressure Equal To or Less Than ½ psig 3.5 kPaPressure Testing Heater Gas Connections Electrical Wiring DiagramOperating Your Heater What to do if YOU Smell GASLighting Instructions For IR Heaters onlyTo Turn OFF GAS to Appliance Shutting OFF HeaterShutting OFF Burner only Pilot Stays LIT Turn control knob clockwise to the PILOT/IGN positionThermostat Control Operation Inspecting BurnerPilot Flame Pattern Burner Flame PatternCleaning and Maintenance Cleaning ODS/PILOT and BurnerCleaning Burner Pilot AIR Hole Inlet Cleaning Heater CabinetTroubleshooting Observed Symptom Possible Cause RemedyControl knob not in pilot position Troubleshooting CON’T Observed Symptom Possible Cause RemedySpecifications IR10 LP IR20LPT IR30LPTBF10LP BF20LPT BF30LPT Replacement Parts Parts Under WarrantyParts not Under Warranty Technical ServiceThermostat models BF20LPT BF30LPTIR20LPT IR30LPT Parts List Thermostat modelsIR20LPT, IR30LPT, BF20LPT, BF30LPT IR20LPT BF20LPT IR30LPT BF30LPTNot sold separately Must purchase Assembly Items not shown 7068370684 31-1 70685NON-Thermostat models IR10LP BF10LPNon-Thermostat model IR10LP, BF10LP, IR10 LP, BF10LPDescription QTY IR10LP BF10LPDescription QTY Warranty Information Keep this warrantyModel Serial No Date Purchased Ansi Z21.11.2b-2004
Related manuals
Manual 24 pages 60.62 Kb Manual 24 pages 35.26 Kb

MHBF20LPT, TSBF20LPT, MHBF10LP, TSBF10LP, HSBF20LPT specifications

The Enerco MHBF10LP, TSBF10LP, HSBF10LP, HSBF20LPT, and TSBF20LPT are innovative heating solutions designed for both commercial and residential applications. These units are highly efficient gas-fired heaters offering versatile heating capabilities, ensuring user comfort in various settings.

The MHBF10LP is a liquid propane heater featuring a powerful output of 10,000 BTU. It operates with a direct ignition system, allowing for quick and reliable startups. Its compact design makes it suitable for smaller spaces, while the adjustable heat settings empower users to customize their warmth. The MHBF10LP boasts a safety shut-off system which enhances the overall safety of the unit.

In contrast, the TSBF10LP is engineered for portability, offering the same 10,000 BTU output but with added mobility features. It comes with a built-in carrying handle and lightweight design, making it easy to transport from one location to another. Perfect for job sites or outdoor events, it features a sturdy construction that withstands demanding environments and a direct ignition system for ease of use.

The HSBF10LP, another variant in this range, offers high-efficiency heating in a small footprint. This model stands out with its integrated fan that aids in even heat distribution. Users can quickly warm up spaces without the long wait times. Additionally, it provides options for permanent installation, making it an adaptable choice for various applications.

The HSBF20LPT and TSBF20LPT models deliver enhanced power with a heating capacity of 20,000 BTU. The HSBF20LPT focuses on high efficiency and user convenience, featuring an automatic thermostat control to maintain desired temperatures without constant adjustment. Its robust design is perfect for larger areas, ensuring consistent warmth and comfort.

On the other hand, the TSBF20LPT is portable like its 10,000 BTU counterpart but with double the capacity. Its rugged construction and portability make it ideal for both indoor and outdoor use. The unit's reliability in diverse conditions is coupled with an ease of operation, providing warmth where it's most needed.

All models in this Enerco range prioritize user safety and efficiency. Featuring built-in safety mechanisms such as flame failure protection and tip-over shut-off systems, each heater ensures safe operation. Furthermore, the robust construction and high-quality materials used in these devices promise durability, making them a worthwhile investment for long-term heating needs.

Overall, Enerco's MHBF and TSBF series heaters represent a blend of modern technology, safety features, and user-friendly designs, tailored for a variety of heating applications.