Oki C5510 instruction manual To Assemble Wheels, Assemble Rubber Feet

Page 10

6.If the handle has excessive movement, it is improperly installed. Check the following.

A.Are both tabs inside the handle (Step #3)?

B.Does each clip pass through both the saddle and handle (Step #4)?

To Assemble Wheels

It will be necessary to brace or support one side of the

unit when installing the wheels because the compressor will have a tendency to tip.

1.Attach wheels with shoulder bolts and nuts as shown.

2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.

The wheels and handle do not provide adequate

clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

Wheel Nut

Shoulder Bolt

Assemble Rubber Feet

1.Attach rubber feet with the screws, washers, and nuts provided as shown.

2.Tighten securely.

Nut

Flat

Washer

Rubber Foot Screw

A10260

10- ENG

Image 10

Contents Oillube Single-Stage Portable Compressor Safety Guidelines Definitions Important Safety InstructionsHazard Attachments & Accessories Electricity. Like any other electrically Hazard Warning Risk from Moving Parts Equip area of operation with a fire extinguisher Glossary SpecificationsAccessories Duty CycleTo Install Handle AssemblyTools Required for Assembly UnpackingTo Assemble Wheels Assemble Rubber FeetTo Add Oil To Pump Installation Location of the Air CompressorVoltage and Circuit Protection Extension Cords120/240 Dual Voltage Motor Know Your Air Compressor OperationDescription of Operation How to Use Your Unit Before StartingHow to Start Before Each Start-UpMaintenance Customer ResponsibilitiesChecking ChangingAir Filter Inspection and Replacement To Replace BeltMotor Pulley/Flywheel Alignment Service and Adjustments To Replace or Clean Check ValveTo Replace Regulator Storage Troubleshooting Problem Cause CorrectionWhile accessory is being Problem Cause Correction Problem Cause Correction Limited Warranty