Rollei CWC200ST manual Operation Instructions, General Maintenance

Page 8

OPERATION INSTRUCTIONS

Pre-Start Procedures:

1.Inspect the compressor for any damaged components. Do not operate if compressor is damaged.

2.Check oil level in the compressor pump (See “Checking Oil Level”).

3.Verify that the tanks have been drained and are clear of any moisture or dirt (See “Draining Tank”).

4.Verify that the air filter is securely in place (See “Air Filter Installation”).

Start-Up Procedures:

1.Verify that the On/Off switch is in the Off position.

2.Verify that the tank air pressure is at 0 PSI.

3.Attach the air hose to the discharge line.

4.Plug the unit into a properly grounded outlet.

5.Pull out the On/Off switch to On. The compressor will automatically cycle on and off to keep the tank pressure maintained .

6.Adjust the pressure regulator to the proper pressure setting required for the air tool.

Shut-Off Procedures:

1. Push in the On/Off switch to the Off position.

GENERAL MAINTENANCE

Service and Maintenance:

Prior to performing service and maintenance to the compressor, always disconnect all accessories and attachments from the unit and disconnect the compressor from the electrical source. When replacing parts, only use Genuine BOSTITCH replacement parts.

Checking the pump Oil Level:

1.Verify that the compressor is turned off and on a level surface.

2.Remove oil fill plug - Add until oil reaches “MAX” oil notch in oil fill plug.

-8-

Image 8

Contents Operation and Maintenance Manual CWC200STIndex Limited WarrantyIntroduction Attachments and Accessories Rules for Safe OperationBe Educated Avoid Moving Parts Personal ProtectionRules for Safe Operation Air TanksVentilation Risk of Burns Safety Valve Electrical Grounding InstructionsElectrical Grounding Instructions Duty CycleFeatures of the Bostitch CWC200ST General Maintenance Operation InstructionsGeneral Maintenance Checking/Cleaning the Air FilterChanging the Oil Draining Tank Twist-Style Drain CocksTrouble Shooting Guide Problem CauseIntroducción ÍndiceNotas Garantía LimitadaReglas Para EL Funcionamiento Seguro Reglas Para EL Funcionamiento Seguro continuación Tanques de aireVentilación Peligro de quemadurasInstrucciones DE Conexión Eléctrica a Tierra Válvula de seguridadInstrucciones DE Conexión Eléctrica a Tierra continuación Si debe usar un cable de extensión, use estas directricesCaracterísticas DEL Bostitch CWC200ST Instrucciones DE Operación Mantenimiento GeneralMantenimiento General continuación Cambio de aceiteDrenaje del tanque Grifo de drenaje que se gira Verificación y limpieza del filtro de aireGuía Para Solucionar Problemas Problema Causa probable CorrecciónRemarque Garantie LimitéeRègles Pour UNE Utilisation Sans Risque Réservoirs d’air Risque de brûluresInstructions DE Mise À LA Terre Soupape de sûretéCycle DE Service Instructions DE Mise À LA Terre suiteFonctions DU Modèle Bostitch CWC200ST Instructions D’UTILISATION Entretien GénéralVérification/nettoyage du filtre à air Entretien Général suiteVidange de l’huile Guide DE Dépannage Problème Cause probable