ASSEMBLING FENCE CARRIAGE ASSEMBLY
1.Fasten fence carriage assembly (A) Fig. 15, to cutterhead pulley guard/carriage mounting bracket (C). Align the holes in the fence carriage assembly (A) one of which is shown at (D), with the holes in the pulley guard/carriage mounting bracket (C). Place a M8.1 lockwasher (E), then an M8 flat washer on an M8x1.25x20mm hex socket head screw (B). Insert the screw through the hole in the fence carriage assembly, and thread the screw into the tapped hole in the cutterhead pulley guard/carriage mounting bracket and tighten securely. Repeat this process for the remaining hole in the fence carriage assembly and the cutterhead pulley guard/carriage mounting bracket.
2.Fig. 16, illustrates fence carriage assembly properly mounted.
A
D
FE
C
B
Fig. 15
ASSEMBLING FENCE
1.Fasten fence (A) Fig. 17, to fence carriage assembly
(C) through holes (D). Align the two holes (G) in the fence with the two holes (D) in the carriage assembly (C). Place a M8.1 lockwasher (E), then an M8 flat washer (F), on an M8x1.25x25mm hex socket head screw (B). Insert the screw through hole (D) in the carriage assembly and thread the screw into the tapped hole (G) in the fence, and tighten securely. Repeat this process for the remaining hole in the fence and carriage assembly.
2.Fig. 18 illustrates fence properly mounted.
3.Thread shorter fence handle (E ) Fig.19, into infeed end of fence (A) and longer fence handle (G) into outfeed end as shown.
Fig. 16
A
G
C
F
E BD
Fig. 17
G 
E
A
Fig. 18 | Fig. 19 |
10