ASSEMBLING
JOINTER TO STAND
1.The outfeed end (N) Fig. 9, of the jointer must be pointing toward the end of the stand with dust chute opening (B) Fig. 7.
2.Remove three screws (C) Fig. 7, and loosen two screws (D). Then remove back panel (E) from stand by lifting upward.
3.Line up the three holes (F) Fig. 8, on the top of stand with the three threaded holes on the bottom of the jointer base. Using the supplied 8mm hex wrench (G) Fig. 9, fasten the jointer to the stand. Place a M10.2 lockwasher (I), on a M10x1.5x20mm hex socket head screw (H), and a M10 flat washer onto the screw. Insert the screw through the hole in the stand and thread the screw into the tapped hole in the bottom of the jointer, and tighten securely. Repeat this process for the two remaining holes in the stand and the jointer. NOTE: The mounting hole located on the dust chute end of the stand is accessed by reaching up through the dust chute.
ASSEMBLING
MOTOR PULLEY
Assemble motor pulley (K) Fig. 10, to motor shaft with the hub of the pulley in the outer position as shown. Make certain key (L) is inserted in the keyway of the pulley and motor shaft, then tighten set screw (M) using the 2.5mm hex wrench (not shown).
B
C
E
D
Fig. 7
F
Fig. 8
G J N
I
H
Fig. 9
M 
K
L
Fig. 10
8