Delta 37-275X, 37-195 instruction manual Jointer Parts

Page 6

JOINTER PARTS

1

2

3

4

5

6

7

	8
	9			11
						12
						12
				13
		14		15
		14		15
	10

						Fig. 4
1.	Jointer			9.			12-14mm Open End Wrench
2.	Fence Carriage Assembly			10.			8-10mm Open End Wrench
3.	Cutterhead Pulley Guard/Carriage Mounting			11.			8mm Hex Wrench
Bracket				12.			6mm Hex Wrench
				12.			6mm Hex Wrench
4.	Switch Mounting Bracket			13.			4mm Hex Wrench
				13.			4mm Hex Wrench
5.	Cutterhead Guard			14.			3mm Hex Wrench
				14.			3mm Hex Wrench
6.	Fence Tilting Handles (2)			15.			2.5mm Hex Wrench
				15.			2.5mm Hex Wrench

7.Fence

8.Push Blocks (2)

6

Image 6

Contents Professional Jointer Safety Guidelines / Definitions General Safety RulesAdditional Safety Rules for Jointers Refer to them often Use them to instruct othersPower Connections Unpacking and Cleaning Extension CordsJointer Parts Assembly Stand and ElectricalsAssembling Jointer to Stand Assembling Motor PulleyAdjusting Belt Tension Assembling Belt and Aligning PulleysAssembling Fence Carriage Assembly Assembling FenceAssembling Switch and Mounting Bracket Assembling Cutterhead GuardOperating Controls and Adjustments Assembling Dust ChuteStarting and Stopping Jointer Locking Switch OFF Position Infeed Table AdjustmentsOutfeed Table Adjustments Knife AdjustmentsInfeed Table Positive Stops Page Adjusting Table Gibs Fence OperationAdjusting Fence Positive Stop Lock nut D. Turn adjustment screw a untilREMOVING, REPLACING, and Resetting Knives Placement of Hands During Feeding OperationJointing AN Edge Taper Cuts SurfacingBeveling Cutting a RabbetSurfacing Short Or Thin Work Maintenance and RepairsSurfacing Warped Pieces Direction of GrainPushstick Constructing a Push StickAccessories Canadian PORTER-CABLE Delta Service Centers