Delta 37-275X, 37-195 instruction manual Operating Controls and Adjustments, Assembling Dust Chute

Page 12

ASSEMBLING DUST CHUTE

The jointer stand has a built-in dust chute (A) Fig. 25. If this machine is to be used with a dust collection system, the supplied dust collector connector (B) Fig. 26, can be fastened to jointer stand (C) with four #10-16x1/2" sheet metal screws (D) as shown.

A standard 4" dust collection hose can be attached to dust collector connector.

A

D B

C

Fig. 25	Fig. 26

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING JOINTER

1.The on/off switch is located underneath the switch shield (B) Fig. 31. To start the jointer, move switch (A) up to the “ON” position.

2.To turn the jointer “OFF”, push down on switch shield (B) Fig. 32, as shown.

B

A

Fig. 31

B

Fig. 32

12

Image 12

Contents Professional Jointer Safety Guidelines / Definitions General Safety RulesAdditional Safety Rules for Jointers Refer to them often Use them to instruct othersPower Connections Unpacking and Cleaning Extension CordsJointer Parts Assembly Stand and ElectricalsAssembling Jointer to Stand Assembling Motor PulleyAdjusting Belt Tension Assembling Belt and Aligning PulleysAssembling Fence Carriage Assembly Assembling FenceAssembling Switch and Mounting Bracket Assembling Cutterhead GuardOperating Controls and Adjustments Assembling Dust ChuteStarting and Stopping Jointer Locking Switch OFF Position Infeed Table AdjustmentsOutfeed Table Adjustments Knife AdjustmentsInfeed Table Positive Stops Page Adjusting Table Gibs Fence OperationAdjusting Fence Positive Stop Lock nut D. Turn adjustment screw a untilREMOVING, REPLACING, and Resetting Knives Placement of Hands During Feeding OperationJointing AN Edge Surfacing BevelingTaper Cuts Cutting a RabbetMaintenance and Repairs Surfacing Warped PiecesSurfacing Short Or Thin Work Direction of GrainPushstick Constructing a Push StickAccessories Canadian PORTER-CABLE Delta Service Centers