Delta 37-275X, 37-195 instruction manual Pushstick, Constructing a Push Stick

Page 22

CONSTRUCTING A PUSH STICK

Narrow pieces of stock that are close to 10 inch minimum length should be handled with a push stick and push block. The Fig. below is a pattern for a push stick.

PUSHSTICK	MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT		NOTCHTOHELP PREVENTHAND FROMSLIPPING
	CUTOFFHERETO PUSH1/4"WOOD	CUTOFFHERETO PUSH1/2"WOOD	1/2"SQUARES

Image 22

Contents Professional Jointer Safety Guidelines / Definitions General Safety RulesAdditional Safety Rules for Jointers Refer to them often Use them to instruct othersPower Connections Unpacking and Cleaning Extension CordsJointer Parts Assembly Stand and ElectricalsAssembling Jointer to Stand Assembling Motor PulleyAdjusting Belt Tension Assembling Belt and Aligning PulleysAssembling Fence Carriage Assembly Assembling FenceAssembling Switch and Mounting Bracket Assembling Cutterhead GuardAssembling Dust Chute Operating Controls and AdjustmentsStarting and Stopping Jointer Locking Switch OFF Position Infeed Table AdjustmentsKnife Adjustments Outfeed Table AdjustmentsInfeed Table Positive Stops Page Adjusting Table Gibs Fence OperationAdjusting Fence Positive Stop Lock nut D. Turn adjustment screw a untilREMOVING, REPLACING, and Resetting Knives Operation Placement of Hands During FeedingJointing AN Edge Taper Cuts SurfacingBeveling Cutting a RabbetSurfacing Short Or Thin Work Maintenance and RepairsSurfacing Warped Pieces Direction of GrainPushstick Constructing a Push StickAccessories Canadian PORTER-CABLE Delta Service Centers

CONSTRUCTING A PUSH STICK

PUSHSTICK