Powermatic 1285 operating instructions Unpacking, Contents of the Shipping Container

Page 8

Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

NOTE: The wrenches and knife setting gauge will be found inside the jointer stand.

Contents of the Shipping Container

1 Jointer

1Fence Assembly

1Dust Hood

1Knife Setting Gauge

1Hex Wrench, 10mm

1Combination Wrench, 10-12mm

2Push Blocks

1Owner's Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

8

Image 8

Contents Jointer Part No. M-0460216Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Figure a Page Introduction Specifications 90, 45 right, 45 leftContents of the Shipping Container UnpackingTools need for assembly AssemblyFence Installation Dust Hood Switch ArmGrounding Instructions Voltage Conversion Extension cordsDrive Belt Tension AdjustmentsSetting Outfeed Table Height Page Setting Infeed Table Height Depth of Cut Replacing and Setting Knives Straight CutterheadPage Replacing Knife Inserts Helical Cutterhead Fence Adjustments To check and adjust the 90-degree stopTo tilt fence forward To tilt fence backwardTo check and adjust the 45-degree stop Operating ControlsOperation Cutter Guard TensionHand Placement Edge JointingSurfacing RabbetingJointing Warped Surfaces Jointing Short or Thin WorkDirection of Grain BevelingCutterhead Repairs MaintenanceLubrication Knife Inserts Helical Cutterhead Whetting Knives Straight Cutterhead Probable Cause Remedy Troubleshooting Operating ProblemsTrouble Troubleshooting Mechanical and Electrical Problems Trouble Probable Cause RemedyIf electric motor is suspect, you have Optional Accessories Replacement PartsParts List Stand Assembly Index No. Part No Description Size QtyStand Assembly Parts List Table Assembly Table Assembly Parts List Motor Pulley Assembly Motor Pulley Assembly Parts List Cutterhead Guard Assembly Cutterhead Guard Assembly Parts List Straight Cutterhead Assembly PJ1285-KSGAStraight Cutterhead Assembly Parts List Helical Cutterhead Assembly Helical Cutterhead Assembly Parts List Fence Assembly Fence Assembly Electrical Connections 1 Phase Electrical Connections 3 Phase WMH Tool Group

Related manuals

Manual 40 pages 39.08 Kb