TYPICAL APPLICATIONS
TRIMMING 3/4" | SCRIBING OF | |
VERTICAL BACKSPLASH | OF INSTALLED CORNER | BACKSPLASH TO WALL |
|
|
|
APPLICATION – Trimming front edge of |
| APPLICATION – Accurately scribing the back | |||
3/4" vertical backsplash. This is an opera- | APPLICATION – Trimming into and | ||||
tion standard trimmers with round or | side of a preassembled panel or | ||||
square bases are unable to do without | out of installed backsplash corner | backsplash. Once the lip is accurately scribed, | |||
the use of a special bit. | with little or no hand trimming | the trimmed portion is then pushed against the | |||
|
| required. | wall and mated exactly. |
| |
|
|
|
|
| Front edge |
|
| Triangular base |
|
| of trimmer |
|
| enables complete |
|
| is guided |
|
| corner trimming |
|
| against |
|
| with backsplash |
|
| wall. |
|
| in place. |
|
|
|
|
|
|
|
| |
|
|
| follows every |
| |
Triangular base |
|
| trimmer movement |
| |
guides trimmer for |
|
|
| ||
enables trimming with |
|
| to create exact |
| |
|
|
| |||
backsplash in place. |
|
| reproduction of wall |
| |
every time. |
|
| Maintain 3/4" separation | ||
|
| surface in one pass! | |||
|
|
|
| from wall for scribing. | |
|
|
|
|
| |
OPERATION – Trimming 3/4" backsplash |
|
|
| ||
OPERATION – The new |
|
| |||
| OPERATION – The guide assembly must be | ||||
with the new | Offset Trimmer will trim into and out |
| removed. Using the | ||
Trimmer fitted with a solid carbide self- | of 90° corners with ease using self- |
| |||
piloted bit. |
| piloted bit. |
| accurately to the wall surface. | |
|
|
|
|
|
|
Trims odd angled corners less than or greater than 90°.
Trims up to vertical surfaces.
UNDERSCRIBE 7320 TRIMMER ASSEMBLY
The Underscribe Trimmer Base is assembled to the Model 7301 Trimmer Motor as follows:
NOTE: The 43109 Trim Bit must be installed into the Trimmer Motor before attaching the motor to the Underscribe Base.
DISCONNECT TOOL FROM POWER SOURCE.
1.Clean and insert shank of bit (A) Fig. 14, into collet until end of shank
18