Miller Electric OM-193 084E manual Directives, Standards

Page 4

Declaration of Conformity For

European Community (CE) Products

Manufacturer’s Name:

Manufacturer’s Address:

Declares that the product:

Miller Electric Mfg. Co.

1635 W. Spencer Street Appleton, WI 54914 USA

XMT 304

conforms to the following Directives and Standards:

Directives

Electromagnetic compatibility Directives: 89/336/EEC, 92/31/EEC

Low Voltage Directive: 73/23/EEC

Machinery Directives: 89/392/EEC, 91/368/EEC, 93/C 133/04, 93/68/EEC

Standards

Electromagnetic compatibility (EMC) Product standard for arc welding equipment:

EN50199: December 1995

Safety Requirements for Arc Welding Equipment part 1: EN 60974-1: 1989

Degrees of Protection provided by Enclosures (IP code): IEC 529: 1989

Insulation coordination for equipment within low-voltage systems:

Part 1: Principles, requirements and tests: IEC 664-1: 1992

European Contact: Mr. Luigi Vacchini, Managing Director

MILLER Europe S.P.A.

Via Privata Iseo

20098 San Giuliano

Milanese, Italy

Telephone: 39(02)98290-1

Fax: 39(02)98281-552

dec_con1 10/95

Image 4

Contents Processes OM-193 084EDescription From Miller to You Table of Contents Directives StandardsSymbol Usage Marks a special safety messageArc Welding Hazards Electric Shock can killARC Rays can burn eyes and skin Welding can cause fire or explo- sionFlying Metal can injure eyes Buildup of GAS can injure or killPrincipal Safety Standards EMF Information About PacemakersSignification des symboles Consignes DE Securite Lire Avant UtilisationUN Choc É Lectrique peut tuer LES Fumé ES ET LES GAZ peuvent ê tre dangereuxDES Particules Volantes peuvent blesser les yeux LE Soudage peut provoquer un incendie ou une explosionLE Bruit peut affecter l’ouïe Risque D’INCENDIE OU LA Chute DE L’APPAREIL peut blesser’EMPLOI Excessif peut DES Organes Mobiles peuvent provoquer des blessuresInformation sur les champs é lectromagné tiques Principales normes de sé curitéConsignes relatives aux stimulateurs cardiaques Definitions Manufacturer’s Warning Label Definitions60 s Falling equipment can cause injury and damage to unitManufacturer’s Rating Labels I1max Symbols And DefinitionsI1eff Specifications InstallationDuty Cycle And Overheating CV Mode CC ModeVolt-Ampere Curves Dimensions And Weight Do not move or operate unit where it could tipSelecting a Location MovementWeld Output Terminals And Selecting Cable Sizes Remote 14 Receptacle InformationARC Welding can cause Electromagnetic Interference TerminalsElectrical Service Guide Connecting Input PowerOperation Front Panel ControlsPPP Meter FunctionsMode Switch Settings Mode Output ControlProcedure requires Lift-Arc Trigger Hold TIGDo not remove case when blowing out inside of unit Maintenance & TroubleshootingBlowing Out Inside Of Unit HE.L P-9 Voltmeter/Ammeter Help DisplaysTroubleshooting Circuit Breakers CB1 And CB2Electrical Diagram Circuit Diagram For Welding Power SourceParts List Main AssemblyDia Part 207 OM-193 084 OM-193 084 Service SupportOwner’s Record Miller Electric Mfg. Co