Miller Electric OM-193 084E manual 60 s, Falling equipment can cause injury and damage to unit

Page 14

	3	4	1	5	6
2	3	4		5	6
					V
		V
			> 60 s	V
					S-185 836
	7	8	9		10

1Warning! Watch Out! There are possible hazards as shown by the symbols.

2Electric shock from wiring can kill.

3Disconnect input plug or power before working on machine.

4Hazardous voltage remains on input capacitors after power is turned off. Do not touch fully charged capacitors.

5Always wait 60 seconds after power is turned off before working on unit, OR

6Check input capacitor voltage, and be sure it is near 0 before touching any parts.

7When power is applied failed parts can explode or cause other parts to explode.

8Flying pieces of parts can cause injury. Always wear a face shield when servicing unit.

9Always wear long sleeves and button your collar when servicing unit.

10After taking proper precautions as shown, connect power to unit.

11/98

		1
∠	= <60 °
∠
			S-179 309-A
2	3	4	5

1Warning! Watch Out! There are possible hazards as shown by the symbols.

2Falling equipment can cause injury and damage to unit.

3Always lift and support unit using both handles. Keep angle of lifting device less than 60 degrees.

4Use a proper cart to move unit.

5Do not use one handle to lift or support unit.

1/96

OM-193 084 Page 10

Image 14

Contents Description OM-193 084EProcesses From Miller to You Table of Contents Directives StandardsArc Welding Hazards Symbol UsageMarks a special safety message Electric Shock can killFlying Metal can injure eyes ARC Rays can burn eyes and skinWelding can cause fire or explo- sion Buildup of GAS can injure or killPrincipal Safety Standards EMF Information About PacemakersUN Choc É Lectrique peut tuer Signification des symbolesConsignes DE Securite Lire Avant Utilisation LES Fumé ES ET LES GAZ peuvent ê tre dangereuxLE Bruit peut affecter l’ouïe LE Soudage peut provoquer un incendie ou une explosionDES Particules Volantes peuvent blesser les yeux ’EMPLOI Excessif peut Risque D’INCENDIE OULA Chute DE L’APPAREIL peut blesser DES Organes Mobiles peuvent provoquer des blessuresConsignes relatives aux stimulateurs cardiaques Principales normes de sé curitéInformation sur les champs é lectromagné tiques Definitions Manufacturer’s Warning Label Definitions60 s Falling equipment can cause injury and damage to unitManufacturer’s Rating Labels I1eff Symbols And DefinitionsI1max Duty Cycle And Overheating InstallationSpecifications Volt-Ampere Curves CC ModeCV Mode Selecting a Location Dimensions And WeightDo not move or operate unit where it could tip MovementARC Welding can cause Electromagnetic Interference Weld Output Terminals And Selecting Cable SizesRemote 14 Receptacle Information TerminalsElectrical Service Guide Connecting Input PowerOperation Front Panel ControlsPPP Meter FunctionsMode Switch Settings Mode Output ControlProcedure requires Lift-Arc Trigger Hold TIGBlowing Out Inside Of Unit Maintenance & TroubleshootingDo not remove case when blowing out inside of unit HE.L P-9 Voltmeter/Ammeter Help DisplaysTroubleshooting Circuit Breakers CB1 And CB2Electrical Diagram Circuit Diagram For Welding Power SourceParts List Main AssemblyDia Part 207 OM-193 084 OM-193 084 Service SupportOwner’s Record Miller Electric Mfg. Co