Cisco Systems PA-4R manual Contents

Page 1

PA-4R Half-Duplex Token Ring Port Adapter

Installation and Configuration

Product Numbers: PA-4R and PA-4R=

This configuration note describes the installation and configuration of the half-duplex PA-4R(=) Token Ring port adapter, which can be used in the following supported platforms:

•Cisco 7200 series routers,, which consists of the 2-slot Cisco 7202, 4-slot Cisco 7204, and the 6-slot Cisco 7206

•Second-generation Versatile Interface Processor (VIP2) in all Cisco 7500 series routers and Cisco 7000 series routers. (Refer to the section “Software and Hardware Requirements” on page 2.)

Note For VIP2 users, use this configuration note in conjunction with the configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and Configuration (Document Number 78-2658-xx), which shipped with your VIP2.

For Cisco 7200 series router users, use this configuration note in conjunction with the Cisco 72xx Installation and Configuration Guide that shipped with your Cisco 7200 series router.

Contents

This configuration note is organized into the following sections:

•Port Adapter Installation Prerequisites, page 2

•What Is the 4R Port Adapter?, page 9

•VIP2 and the 4R Port Adapter, page 13

•Cisco 7200 Series and the 4R Port Adapter, page 27

•Related Documentation, page 38

•Obtaining Documentation, page 39

•Obtaining Technical Assistance, page 40

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Copyright © 1996–2002. Cisco Systems, Inc. All rights reserved.

Image 1

Contents Contents Software and Hardware Requirements Port Adapter Installation PrerequisitesChecking Hardware and Software Compatibility Safety GuidelinesList of Parts and Tools Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesToken Ring Overview Token Ring SpecificationsPreventing Electrostatic Discharge Damage IBM Token Ring and Ieee 802.5 Comparison Token Ring Distance Limitations Token Ring Connection EquipmentToken Ring Speed Considerations What Is the 4R Port Adapter?Dram Port adapter slot Blank port adapter 4R Port Adapter LEDs4R Port Adapter Cables 4R Port Adapter Receptacles, Cables, and Pinouts4R Port Adapter Receptacle Pinout VIP2 and the 4R Port AdapterInstalling or Replacing a Port Adapter on a VIP2 Location of Port Adapter Screw Partial Port Adapter View Aligning a Port Adapter in a Port Adapter Slot H3152 Token Ring Interface Cable Connections Attaching 4R Port Adapter Interface CablesConfiguring the 4R Interfaces At the Exec prompt for a router, enter the enable command Using the Exec Command InterpreterBrackets Using the Setup Command FacilityConfiguring interface parameters Configuring Interfaces Using the configure CommandChange the default shutdown state and enable the interface Using show Commands to Verify the VIP2 Status Checking the ConfigurationRouter# sh int tokenring 3/0/0 Using the ping Command 4R port adapter Cisco 7200 Series and the 4R Port AdapterRemoving a Port Adapter Handling a Port Adapter Replacing a Port AdapterPort adapter Handle Configuring the 4R Interfaces Cisco 7200 Series and the 4R Port Adapter Routerconfig-if#ip address 1.1.1.10 Configuring InterfacesUsing show Commands to Verify the New Interface Status Using show Commands to Display Interface Information Board revision A0 Serial number 2023868 Part number Router# ping 1.1.1.10 Return Type escape sequence to abort Obtaining Documentation, Obtaining Technical Assistance, Related DocumentationWorld Wide Web Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationCisco.com Obtaining Technical AssistanceTechnical Assistance Center Cisco TAC Escalation Center Cisco TAC Web SiteOL-3589-01