Cisco Systems PA-4R manual Aligning a Port Adapter in a Port Adapter Slot

Page 16

VIP2 and the 4R Port Adapter

Figure 10 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)

H3149

Step 7 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.

Step 8 Remove the new port adapter from its antistatic container and position it at the opening of the slot. (See Figure 11.)

Step 9 Carefully align the port adapter carrier between the upper and lower edges of the port adapter slot, as shown in Figure 11.

Figure 11 Aligning a Port Adapter in a Port Adapter Slot

H3150

Carrier

Upper edge

Lower edge

Caution To prevent jamming the carrier between the upper and lower edges of the port adapter slot and to ensure that the edge connector at the rear of the port adapter seats in the connector at the rear of the port adapter slot, make certain that the leading edges of the carrier are between the upper and lower slot edges, as shown in the cutaway in Figure 11.

PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration

16

OL-3589-01

 

 

Image 16
Contents Contents Port Adapter Installation Prerequisites Software and Hardware RequirementsChecking Hardware and Software Compatibility Safety GuidelinesList of Parts and Tools Safety Warnings Telephone Wiring Guidelines Electrical Equipment GuidelinesToken Ring Overview Token Ring SpecificationsPreventing Electrostatic Discharge Damage IBM Token Ring and Ieee 802.5 Comparison Token Ring Connection Equipment Token Ring Distance LimitationsWhat Is the 4R Port Adapter? Token Ring Speed ConsiderationsDram 4R Port Adapter LEDs Port adapter slot Blank port adapter4R Port Adapter Receptacles, Cables, and Pinouts 4R Port Adapter CablesVIP2 and the 4R Port Adapter 4R Port Adapter Receptacle PinoutInstalling or Replacing a Port Adapter on a VIP2 Location of Port Adapter Screw Partial Port Adapter View Aligning a Port Adapter in a Port Adapter Slot H3152 Attaching 4R Port Adapter Interface Cables Token Ring Interface Cable ConnectionsConfiguring the 4R Interfaces Using the Exec Command Interpreter At the Exec prompt for a router, enter the enable commandUsing the Setup Command Facility BracketsConfiguring Interfaces Using the configure Command Configuring interface parametersChange the default shutdown state and enable the interface Checking the Configuration Using show Commands to Verify the VIP2 StatusRouter# sh int tokenring 3/0/0 Using the ping Command Cisco 7200 Series and the 4R Port Adapter 4R port adapterRemoving a Port Adapter Replacing a Port Adapter Handling a Port AdapterPort adapter Handle Configuring the 4R Interfaces Cisco 7200 Series and the 4R Port Adapter Configuring Interfaces Routerconfig-if#ip address 1.1.1.10Using show Commands to Verify the New Interface Status Using show Commands to Display Interface Information Board revision A0 Serial number 2023868 Part number Router# ping 1.1.1.10 Return Type escape sequence to abort Related Documentation Obtaining Documentation, Obtaining Technical Assistance,Obtaining Documentation World Wide WebDocumentation CD-ROM Ordering DocumentationCisco.com Obtaining Technical AssistanceTechnical Assistance Center Cisco TAC Web Site Cisco TAC Escalation CenterOL-3589-01