Cisco Systems PA-4R manual Router# ping 1.1.1.10 Return Type escape sequence to abort

Page 37

Cisco 7200 Series and the 4R Port Adapter

The ping command sends an echo request out to a remote device at an IP address that you specify. After sending a series of signals, the command waits a specified time for the remote device to echo the signals. Each returned signal is displayed as an exclamation point (!) on the console terminal; each signal that is not returned before the specified time-out is displayed as a period (.). A series of exclamation points (!!!!!) indicates a good connection; a series of periods (.....) or the messages [timed out] or [failed]

indicate that the connection failed.

Following is an example of a successful ping command to a remote server with the address 1.1.1.10:

Router# ping 1.1.1.10 <Return> Type escape sequence to abort.

Sending 5, 100-byte ICMP Echoes to 1.1.1.10, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/15/64 ms Router#

If the connection fails, verify that you have the correct IP address for the server and that the server is active (powered on), and repeat the ping command.

For complete descriptions of interface subcommands and the configuration options available for Cisco 7206-related interfaces and functionality, refer to the publications listed in the section “If You Need More Information” on page 2.

PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration

	OL-3589-01	37

Image 37

Contents Contents Software and Hardware Requirements Port Adapter Installation PrerequisitesChecking Hardware and Software Compatibility Safety GuidelinesList of Parts and Tools Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesToken Ring Overview Token Ring SpecificationsPreventing Electrostatic Discharge Damage IBM Token Ring and Ieee 802.5 Comparison Token Ring Distance Limitations Token Ring Connection EquipmentToken Ring Speed Considerations What Is the 4R Port Adapter?Dram Port adapter slot Blank port adapter 4R Port Adapter LEDs4R Port Adapter Cables 4R Port Adapter Receptacles, Cables, and Pinouts4R Port Adapter Receptacle Pinout VIP2 and the 4R Port AdapterInstalling or Replacing a Port Adapter on a VIP2 Location of Port Adapter Screw Partial Port Adapter View Aligning a Port Adapter in a Port Adapter Slot H3152 Token Ring Interface Cable Connections Attaching 4R Port Adapter Interface CablesConfiguring the 4R Interfaces At the Exec prompt for a router, enter the enable command Using the Exec Command InterpreterBrackets Using the Setup Command FacilityConfiguring interface parameters Configuring Interfaces Using the configure CommandChange the default shutdown state and enable the interface Using show Commands to Verify the VIP2 Status Checking the ConfigurationRouter# sh int tokenring 3/0/0 Using the ping Command 4R port adapter Cisco 7200 Series and the 4R Port AdapterRemoving a Port Adapter Handling a Port Adapter Replacing a Port AdapterPort adapter Handle Configuring the 4R Interfaces Cisco 7200 Series and the 4R Port Adapter Routerconfig-if#ip address 1.1.1.10 Configuring InterfacesUsing show Commands to Verify the New Interface Status Using show Commands to Display Interface Information Board revision A0 Serial number 2023868 Part number Router# ping 1.1.1.10 Return Type escape sequence to abort Obtaining Documentation, Obtaining Technical Assistance, Related DocumentationWorld Wide Web Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationCisco.com Obtaining Technical AssistanceTechnical Assistance Center Cisco TAC Escalation Center Cisco TAC Web SiteOL-3589-01