Cisco Systems PA-4R manual H3152

Page 17

VIP2 and the 4R Port Adapter

Caution To ensure a positive ground attachment between the port adapter carrier and the VIP2 motherboard and port adapter slot, and to ensure that the connectors at the rear of the port adapter and slot seat properly, position the carrier between the upper and lower slot edges, as shown in Figure 12.

Step 10 Carefully slide the new port adapter into the port adapter slot (Figure 12) until the connector on the port adapter is completely seated in the connector on the motherboard.

Figure 12 Port Adapter Installed in a Port Adapter Slot (Partial Port Adapter View)

H3152

Step 11 Replace the screw in the rear of the port adapter slot. (See for its location.) Do not overtighten this screw.

Step 12 Reinstall the VIP2 in the system. (Follow the steps in the section “Installing a VIP2” in the configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and Configuration [Document Number 78-2658-xx], which shipped with your VIP2.)

Step 13 If disconnected, reconnect the interface cables to the port adapters.

This completes the procedure for installing a new port adapter or replacing a port adapter on a VIP2.

PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration

	OL-3589-01	17

Image 17

Contents Contents Software and Hardware Requirements Port Adapter Installation PrerequisitesList of Parts and Tools Safety GuidelinesChecking Hardware and Software Compatibility Safety Warnings Electrical Equipment Guidelines Telephone Wiring GuidelinesPreventing Electrostatic Discharge Damage Token Ring SpecificationsToken Ring Overview IBM Token Ring and Ieee 802.5 Comparison Token Ring Distance Limitations Token Ring Connection EquipmentToken Ring Speed Considerations What Is the 4R Port Adapter?Dram Port adapter slot Blank port adapter 4R Port Adapter LEDs4R Port Adapter Cables 4R Port Adapter Receptacles, Cables, and Pinouts4R Port Adapter Receptacle Pinout VIP2 and the 4R Port AdapterInstalling or Replacing a Port Adapter on a VIP2 Location of Port Adapter Screw Partial Port Adapter View Aligning a Port Adapter in a Port Adapter Slot H3152 Token Ring Interface Cable Connections Attaching 4R Port Adapter Interface CablesConfiguring the 4R Interfaces At the Exec prompt for a router, enter the enable command Using the Exec Command InterpreterBrackets Using the Setup Command FacilityConfiguring interface parameters Configuring Interfaces Using the configure CommandChange the default shutdown state and enable the interface Using show Commands to Verify the VIP2 Status Checking the ConfigurationRouter# sh int tokenring 3/0/0 Using the ping Command 4R port adapter Cisco 7200 Series and the 4R Port AdapterRemoving a Port Adapter Handling a Port Adapter Replacing a Port AdapterPort adapter Handle Configuring the 4R Interfaces Cisco 7200 Series and the 4R Port Adapter Routerconfig-if#ip address 1.1.1.10 Configuring InterfacesUsing show Commands to Verify the New Interface Status Using show Commands to Display Interface Information Board revision A0 Serial number 2023868 Part number Router# ping 1.1.1.10 Return Type escape sequence to abort Obtaining Documentation, Obtaining Technical Assistance, Related DocumentationWorld Wide Web Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationTechnical Assistance Center Obtaining Technical AssistanceCisco.com Cisco TAC Escalation Center Cisco TAC Web SiteOL-3589-01