4. Service procedures
(G)Confirm and change the indoor unit address
❏The purpose of the above function is to let you confirm the indoor unit address after the auto. address operation, and change the indoor unit address if it is needed.
aPress the TEST / CHK and ( ) buttons at the same time for more than 4 seconds.
AIR FLOW
Section
UNIT
FLAP
R.C.
MODE
1
TIMER SET
SET CL
CODE No. | SET TEMP. |
FAN SPEED
SETTING
SET DATA
ON •
OFF •
TEST / CHK
2
3
0362_M_I
bSelect the R.C. No. which you want to change with the UNIT (up) or FLAP (down) buttons.
cPress the SET button (to confirm the R.C. No.).
The smallest registered indoor No. and the selected R.C. No. will be displayed.
4
AIR FLOW |
|
|
UNIT | UNIT No. | MODE |
FLAP | R.C. No. |
|
|
| |
| CODE No. | SET TEMP. |
TIMER SET |
|
|
| SETTING | FAN SPEED |
|
| |
| SET DATA |
|
SET CL |
|
|
| ON • |
|
| OFF • |
|
|
| TEST / CHK |
Ex:
R.C. No. 3 is selected.
Indoor No. 2 is the smallest indoor No. of the R.C. No. 3.
0363_M_I
dSelect the indoor No. which you want to change with UNIT button. Once in this mode, the fan motor of selected indoor unit will turn on and let you confirm the indoor unit address.
SM830076
– 80 –