To install the Height Knob:
Washer (18)
Nut (56)
Stud (17)
Figure 4
a. Unthread the Shipping Nut (56) from the Stud counterclockwise and remove it from the Stud.
Washer (18)
Height Knob
(16)
Stud (17)
Figure 5
b. Leave the Washer in place and thread the Height Knob (16) onto the Stud clockwise until it is secure.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position, pull out the Switch Key (27b), and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY: Do not operate with ANY guard disabled, damaged, or removed.
Adjusting the Main Spindle Height
The Main Spindle (43) can be adjust up or down by 3/4”.
Lower | Raise | |
Main | ||
Main | ||
Spindle | ||
Spindle | ||
|
Figure 6 | Height Knob |
(16) |
To adjust the height of the Main Spindle (43) turn the Height Knob (16) counter clockwise and slide the Knob to the left to lower, or the right to raise, the height of the Main Spindle. When it is the desired height, tighten the Height Knob clockwise until it is secure.
|
| REV 10e |
Page 10 | For technical questions, please call | SKU 32650 |