Ring Guard
Always use the Shaper/Router with the Ring Guard (11) in place. It is an important safety feature which protects against contact with the blade. Before plugging in the machine, the Ring Guard should be positioned about 1/4” above the workpiece and then locked into place. When you wish to make adjustments or change cutters, you can loosen the Knob (4) holding the Ring Guard and rotate it out of the way.
Ring Guard (11)
Post (12)
Figure 18 | Bolt (10) |
To assemble the Ring Guard, slide the Post (12) into the slot on the Ring Guard and secure in place with the Bolt (10).
Post (12)
Ring Guard (11)
Knob (4)
Figure 19
1.To install the Ring Guard, slide the Post into the hole in the Table Top (7).
2.Secure in place with the Knob (4).
Chip Discharge Chute
The Chip Discharge Chute (9) and Adapter (52) direct loose chips away from the work area. The unit can be set up with a bag or vacuum (both sold separately) to gather loose chips from the work area. The use if a vacuum to aid in chip exhaust is recommended. The machine’s discharge chute, with the adapter included, will allow you to use a
REV 10e |
|
|
SKU 32650 | For technical questions, please call | Page 15 |