Harbor Freight Tools 32650 operating instructions Carbon Brush Replacement

Page 21

Bolts

(35)

Motor

Bracket

(36)

Spindle

Pulley

(38)

Bolts

(35)

Belt (34)

Motor

Pulley

(3e)

Figure 28

5.Remove the old Belt (34) and place a new belt on the Pulleys (3e and 38).

6.If the tension needs adjusting:

a.Loosen the four hex head Bolts (35) on the Motor Bracket (36).

b.Slide the bracket up or down until the sides of the belt are tight.

c.Tighten the bolts and make sure the belt runs straight.

NOTE: Never over-tension belt as this will result in shortened motor bearing life.

7.Replace the belt guard and turn the machine right side up.

Carbon Brush Replacement

Replacement Carbon Brushes (3b) are included with this unit. The Carbon Brushes should be replaced by a qualified technician.

REV 10e
SKU 32650	For technical questions, please call 1-800-444-3353.	Page 21

Image 21

Contents Bench TOP Shaper/Router For technical questions or replacement parts, please callContents General Tool Safety Warnings Save This ManualSave all warnings and instructions for future reference Table a 25’ 50’ 100’ 150’Grounding Instructions Shaper Safety Warnings110-120 V~ Grounded Tools Tools With Three Prong Plugs 125 V~ 3-Prong Plug and OutletVibration Safety For technical questions, please call Unpacking SpecificationsComponentsInstalling the Height Knob Assembly/MountingInstructions for putting Into use MountingTool Set Up Adjusting the Main Spindle HeightOperating Instructions To Install the Shaper Spindle Removing or Installing the Shaper SpindleTo remove the Shaper Spindle SKU For technical questions, please callTable Insert Installing Shaper BitsInstalling Router Bits Guard and Guide Locations FenceChip Discharge Chute Ring GuardMiter Gauge Radius PinWork Piece and Work Area Set Up Switch and KeyShaping and Routing Techniques General Operating InstructionsWood Grain Across the GrainIrregular And Curved Shaping Straight Edge ShapingCleaning, Maintenance, Lubrication Maintenance ServicingCarbon Brush Replacement Problem Possible Causes Likely Solutions TroubleshootingRecord Product’s Serial Number Here Please Read the Following CarefullyPart Description Qty Parts ListAssembly Diagram Limited 1 year / 90 Day warranty