Chip Discharge
Chute (9)
Adapter (52)
Figure 11
1.To add Adapter, slide it into the Discharge Chute.
Fence Assembly (2)
Chip
Discharge
Chute (9)
Adapter (52)
and thread the Radius Pin (6) clockwise into the hole shown above.
Ring Guard (11)
Radius Pin (6)
Figure 22 | Table Top (7) |
|
2.Install the Ring Guard.
|
|
|
|
| Miter Gauge |
| |
Miter Bar (1c) | Miter Knob (1d) | ||
| Slots to secure | ||
|
| ||
Miter Scale (1a) |
| ||
workpiece |
| ||
Figure 20
2.Use the four Bolts (10) to secure the Chute onto the Fence Assembly (2). Attache your vacuum to the end of the Chute or Adapter.
Radius Pin
The Radius Pin (6) is used as a guide for freeform work, in place of the Fence Assembly (2).
Other possible location | Radius Pin (6) |
for Radius Pin |
Figure 23 | Miter Indicator (1b) |
The Miter Gauge Assembly (1) is an adjustable guide that slides along the channel in the Table Top (7) to guide the workpiece into the blade at a specific angle. The unit is adjustable from 0° to ±60°. The workpiece can be secured to the Miter Gauge with pan head screws through the two slots in the face of the gauge.
Figure 21 | Table Top (7) |
1.To set up the Shaper/Router for freeform projects, remove the Fence Assembly (2)
|
| REV 10e |
Page 16 | For technical questions, please call | SKU 32650 |