4.Slide the Washer (13) and the Keyed Washer (48) onto the Shaper Spindle, and thread the Nut onto the end of the Shaper Spindle.
Spindle Wrench (54)
Shaper Spindle (47)
Router Collet Nut (51) | Router Bit |
| (sold separately) |
Nut (49) | Double |
| Ended |
| Wrench |
| (55) |
Cutter
(sold separately)
Figure 13
5.Use the Spindle Wrench (54) to hold the Shaper Spindle in place while tightening the Nut clockwise with the small end of the Double Ended Wrench (55).
WARNING! The Keyed washer must be directly under the Nut (49) or else serious injury may occur. Be careful to tighten the Nut (49) and the Height Knob (16) securely.
Installing Router Bits
1.Remove the Shaper Spindle (47) if it is installed.
Router Bit
Collet (50)
Main Spindle (43) | Table Top (7) |
Figure 14 |
|
2.Insert the Router Bit Collet (50) into the Main Spindle (43).
3.Place the Router Collet Nut (51) over the Router Bit Collet and thread it clockwise so that it is loosely in place on the Main Spindle.
4.Insert the Table Insert (8).
Table Insert
Router Bit
(sold separately)
Router Collet Nut (51) | Table Top (7) |
|
Figure 15
5. Insert the router bit (sold separately) into the Main Spindle.
6. Firmly tighten the bit in place by turning the Router Collet Nut (51) clockwise with the Double Ended Wrench (55)
REV 10e |
|
|
SKU 32650 | For technical questions, please call | Page 13 |